30 ms

1 sec

2-Pulse Strobe

30 ms

70 ms

1 sec

30 ms

1-Pulse Strobe

Figure 1. Timing diagram for 1 pulse or 2 pulses

Specifications

Supply Voltage and Current

12–30 V dc

Rotating models: 140 mA maximum at 12 V dc, 70 mA maximum at 30 V dc

Strobing models: 160 mA maximum at 12 V dc, 100 mA maximum at 30 V dc

Supply Protection Circuitry

Protected against reverse polarity and transient voltages

Indicators

LED function depends on the model and wiring (see

Wiring on page 1)

Indicator Power-Up Response Time

ON: 250 ms

Construction

Base and covers: polycarbonate

Connections

Integral 5-pin M12/Euro-style quick disconnect or 2 m (6.5 ft) integral cable, depending

on model

Operating Conditions

–40 °C to +50 °C (–40 °F to +122 °F)

90% @ 50 °C max. relative humidity (non-condensing)

Environmental Rating

Rated IEC IP67 and IP69K, per DIN 40050

Application Note

Light emits 360° from housing sides and from housing top, some models

Rotating Models

Strobing Models

LIGHT DIRECTION

LIGHT DIRECTION

Vibration and Mechanical Shock

All models meet Mil. Std. 202F requirements method 201A (vibration: 10 to 60 Hz

max., double amplitude 0.06", maximum acceleration 10G). Also meets IEC

947-5-2; 30G 11 ms duration, half sine wave.

Certifications

Required Overcurrent Protection

WARNING: Electrical connections must be made

by qualified personnel in accordance with local

and national electrical codes and regulations.

Overcurrent protection is required to be provided by end product application per

the supplied table.

Overcurrent protection may be provided with external fusing or via Current Limiting,

Class 2 Power Supply.

Supply wiring leads < 24 AWG shall not be spliced.

For additional product support, go to

www.bannerengineering.com.

Supply Wiring (AWG)

Required Overcurrent Protection (Amps)

20

5.0

22

3.0

24

2.0

26

1.0

28

0.8

30

0.5

Dimensions

M12

M30 x 1.5

(mounting nut included)

Max. torque 4.5 Nm (40 in.-lbs)

50

1.97

[

]

49

[1.93]

11

[.43]

29

[1.14]

Internal Threads

1/2 - 14 NPSM

Max. torque 2.25 Nm (20 in.-lbs)

2

www.bannerengineering.com - Tel: + 1 888 373 6767

P/N 159966 Rev. F