S-25C080A H Series

11



Operation

1. Status register

The status register’s organization is below. The status register can Write and Read by a specific instruction.

SRWD

0

b7

b6

0

b5

0

b4

BP1

b3

BP0

b2

WEL

b1

WIP

b0

Status Register Write Disable

Block Protect

Write Enable Latch

Write In Progress

Figure 9 Organization of Status Register

The status/control bits of the status register are as follows.

1. 1 SRWD (b7) : Status register write disable

Bit SRWD operates in conjunction with the Write protect signal ( WP ). With a combination of bit SRWD and signal

WP

(SRWD = “1”, WP = “L”), this device goes in Hardware Protect status. In this case, the bits composed of the

nonvolatile bit in the status register (SRWD, BP1, BP0) go in Read Only, so that the WRSR instruction is not be

performed.

1. 2 BP1, BP0 (b3, b2) : Block protect

Bit BP1 and BP0 are composed of the nonvolatile bit. The area size of Software Protect against WRITE instruction

is defined by them. Rewriting these bits is possible by the WRSR instruction. To protect the memory area against

the WRITE instruction, set either or both of bit BP1 and BP0 to “1”. Rewriting bit BP1 and BP0 is possible unless

they are in Hardware Protect mode. Refer to “ Protect Operation” for details of “Block Protect”.

1. 3 WEL (b1) : Write enable latch

Bit WEL shows the status of internal Write Enable Latch. Bit WEL is set by the WREN instruction only. If bit WEL is

“1”, this is the status that Write Enable Latch is set. If bit WEL is “0”, Write Enable Latch is in reset, so that the S-

25C080A does not receive the WRITE or WRSR instruction. Bit WEL is reset after these operations;

• The power supply voltage is dropping

• Power-on

• After performing WRDI

• After the Write operation by the WRSR instruction

• After the Write operation by the WRITE instruction