Wiring

Wire Purpose

Cable Wire Color1

Continuous On

Mode

Strobed Mode

Terminal Block

Power Wires

Brown (1)

+24 V dc

+24 V dc

Pin 012

Blue (3)

common

common

Pin 02

Strobe Polarity

Control

Gray (5)

open

Active Low: open

Open — Active Low

Active High: connect to common (Blue wire)

Pin 02 — Active High

Strobe Voltage

Wires

White (2)

open

0 V dc = ON (Active Low)

+5 V dc to 24 V dc = OFF (Active Low)

Pin 04

0 V dc = OFF (Active High)

+5 V dc to 24 V dc = ON (Active High)

Black (4)

open

Strobe common

Pin 02

(1) +24V dc

(3) Common

(5)Active High/Active Low

(4) Strobe Common

(2) Strobe (+)

Figure 1. Pinouts for Mating Cordsets

Light Intensity Adjustment

Adjust the light’s intensity by turning the 270° Intensity potentiometer with a small flat-blade screwdriver. Apply power to the light

and turn the potentiometer all the way clockwise for max. intensity. If the object to be sensed is too bright at max. intensity, turn

the potentiometer down a little at a time, testing with the object, until the correct brightness is achieved.

Specifications

Supply Voltage and Current

Operating Voltage: 24 V dc ±10%

Strobe Voltage: 5 V dc to 24 V dc at 15 mA maximum

Current Draw at Full Intensity: 500 mA max

Built-in constant current regulator for LEDs

Adjustable intensity control varies intensity for "P" models

Use only with a suitable Class 2 power supply (UL) or SELV power supply (CE)

Light Source

Five high-intensity LEDs; see models table for wavelengths

Illumination

610 mm (24 in) diameter usable light pattern at 1 m (3.28 ft)

Strobe

Optically isolated

Connections

Integral 5-pin M12/Euro-style quick disconnect, accessory cordset required

Construction

Enclosure rating: IP50 (when mounted using the two ¼ - 20 holes in back)

Housing: aluminum, black anodized

Window: acrylic, clear with frosted diffusing surface on inside

Useful Life

When operated within specifications, output will decrease less than 30%

after 50,000 hours for visible and IR Models; 20,000 hours for UV models

Operating Conditions

Temperature: 0 °C to +50 °C (+32 °F to +122 °F)

Humidity: 90% maximum relative humidity (non-condensing)

Certifications

Light Characteristics

Values shown are typical at 25 °C.

Lumens

mWatts

Cool White

Green

Red

Blue

IR

UV395

LEDxA70

555

435

215

160

1130

610

1 For Banner-supplied wire.

LED..A70XD5-..High-Intensity Area Light

2

www.bannerengineering.com - Tel: + 1 888 373 6767

P/N 153956 Rev. F