Wiring

Wire Purpose

Cable Wire

Color4

Continuous On

Mode

Strobed Mode

PresencePlus Pro

Controller Terminal

Block

(1) +24V dc

(3) Common

(5)Active High/Active Low

(4) Strobe Common

(2) Strobe (+)

Figure 1. Pinouts for Mating Cordset

Power Wires

Brown (1)

+24 V dc

+24 V dc

Pin 015

Blue (3)

common

common

Pin 02

Strobe Polarity

Control

Gray (5)

open

Active Low: open

Open — Active Low

Active High: connect to common (Blue wire)

Pin 02 — Active High

Strobe Voltage

Wires

White (2)

open

0 V dc = ON (Active Low)

+5 V dc to 24 V dc = OFF (Active Low)

Pin 04

0 V dc = OFF (Active High)

+5 V dc to 24 V dc = ON (Active High)

Black (4)

open

Strobe common

Pin 02

Light Intensity Adjustment

Turn the 270° intensity potentiometer with a small flat-blade screwdriver to adjust the light’s intensity.

1. Apply power to the light and turn the potentiometer all the way clockwise for maximum intensity.

2. If the object to be sensed is too bright at maximum intensity, turn the potentiometer counterclockwise, a little at a time,

testing with the target object, until the correct brightness is achieved.

Specifications

Light Source

Four high-intensity LEDs; see models table for wavelengths

Illumination

610 mm (24 in) diameter usable light pattern at 1 m

Strobe

Optically isolated

Supply Voltage and Current

Operating Voltage: 24 V dc ±10%

Strobe Voltage: 5 V dc to 24 V dc @ 15 mA maximum

Current Draw at Full Intensity: 350 mA maximum

Built-in constant current regulator for LEDs

Potentiometer controls variable intensity for “P” models

Use only with a suitable Class 2 power supply (UL) or SELV power supply (CE)

Construction

Enclosure rating: IP50

Housing: aluminum, black anodized

Window: acrylic, clear with frosted diffusing surface on inside

Bracket: aluminum, black anodized. Attaches ring light directly to

PresencePLUS P4 with 2 included M4x14 screws

Useful Life

When operated within specifications, output will decrease less than 30%

after 50,000 hours for visible and IR models, 20,000 hours for UV models

Operating Conditions

Temperature: 0 °C to +50 °C (+32 °F to +122 °F)

Humidity: 90% maximum relative humidity (non-condensing)

Certifications

Light Characteristics

Values shown are typical at 25°C.

Lumens

mWatts

Cool White

Green

Red

Blue

IR

UV395

LEDxR70

390

340

240

130

945

475

4 For Banner-supplied wire.

5 When connecting the light to a PresencePLUS Pro controller terminal block, the controller supply must be 24 V dc ± 10%.

LED High-Intensity Ring Light

2

www.bannerengineering.com - Tel: + 1 888 373 6767

P/N 153910 Rev. F