Specifications

Light Source

LED; wavelengths:

LED Color

Wavelength

Infrared

850 nm

Visible Red

633 nm

Blue

469 nm

Green

525 nm

White

6500 K

Supply Voltage and Current

75 mm x 150 mm models: 24 V dc ± 10% @ 550 mA maximum

150 mm x 150 mm models: 24 V dc ± 10% @ 1.1 A maximum

225 mm x 150 mm models: 24 V dc ± 10% @ 1.65 A maximum

300 mm x 150 mm models: 24 V dc ± 10% @ 2.2 A maximum

Use only with a suitable Class 2 power supply (UL) or SELV power supply (CE)

Connections

Integral 5-pin M12/Euro-style quick disconnect, accessory cordset

required

Operating Conditions

Temperature: 0 °C to +50 °C (+32 °F to +122 °F)

Humidity: 95% maximum relative humidity (non-condensing)

Illumination

Diffused for use in applications needing a backlit light

Useful Life

B50/L50 Lifetime > 100,000 hours (Infrared, Red)

B50/L50 Lifetime > 90,000 hours (Blue, Green, White)

Construction

Environmental Rating

IEC IP67

Certification

This device complies with part 15 of the FCC Rules and CAN ICES-3 (A)/NMB-3(A). Operation is subject to the following two conditions:

1.

This device may not cause harmful interference, and

2.

This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules and CAN ICES-3 (A)/NMB-3(A). These limits are

designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult the manufacturer.

Dimensions

All measurements are listed in millimeters [inches], unless noted otherwise.

75 mm × 150 mm models

M5 - 0.8 X 4

LED Series Sealed Backlights

2

www.bannerengineering.com - Tel: + 1 888 373 6767

P/N 149837 Rev. F