| 数据搜索系统,热门电子元器件搜索 |
|
CS5550 数据表(PDF) 19 Page - Cirrus Logic |
|
|
|||||||||||||||||||||||||||||
CS5550 数据表(HTML) 19 Page - Cirrus Logic |
|
19 / 24 page ![]() CS5550 DS630F1 19 as well as the other defined power states of the CS5550, are described in Section 4.6). Refer to Section 5 of the data sheet to see the de- fault register values for any particular device regis- ter. 4.5 Serial Port Initialization It is possible for the serial interface to become un- synchronized, with respect to the SCLK input. If this occurs, any attempt to clock valid CS5550 commands into the serial interface will result in ei- ther no operation or unexpected operation, be- cause the CS5550 will not interpret the input command bits correctly. The CS5550’s serial port must then be re-initialized. To initialize the serial port, any of the following actions can be performed: 1) Drive (assert) the CS pin low [or if CS pin is al- ready low, drive the pin high, then back to low]. 2) Hardware Reset (drive RESET pin low, for at least 10 µs, then drive back to high). 3) Issue the Serial Port Initialization Sequence, which is performed by clocking 3 (or more) SYNC1 command bytes (0xFF) followed by one SYNC0 command byte (0xFE). 4.6 CS5550 Power States Active state denotes the operation of CS5550 when the device is fully powered on (not in sleep state or stand-by state). Performing either of the following actions will insure that the CS5550 is op- erating in the active state: 1) Power on the CS5550. (Or if the device is al- ready powered on, recycle the power.) 2) Software Reset 3) Hardware Reset In addition to the actions listed above, note that if the device is in sleep state or in stand-by state, the action of waking up the device out of sleep state or stand-by state (by issuing the Power-Up/Halt com- mand) will also insure that the device is set into ac- tive state. In order to send the Power-Up/Halt command to the device, the serial port must be ini- tialized. Therefore, after applying power to the CS5550, a hardware reset should always be per- formed. |
|
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |