FP0707R1-R110-R datasheet(2/5 Pages) EATON

2 / 5 page

Technical Data

10514

Effective March 2016

FP0707R

High frequency, high current power inductors

www.eaton.com/elx

Product specifications

Part Number8

OCL1

(nH) ±10%

FLL2

(nH) minimum

rms

(A)

sat1

(A)

sat2

(A)

sat3

(A)

DCR (mΩ)

±5% @ 20 °C

K-factor7

FP0707R1-R110-R

110

0.30

542

1. Open Circuit Inductance (OCL) Test Parameters: 100 kHz, 0.1 Vrms, 0.0 Adc, +25 °C

2. Full Load Inductance (FLL) Test Parameters: 100 kHz, 0.1 Vrms, I

sat1, +25 °C

3. I

rms: DC current for an approximate temperature rise of 40 ºC without core loss. Derating is

necessary for AC currents. PCB layout, trace thickness and width, air-flow, and proximity of

other heat generating components will affect the temperature rise. It is recommended that the

temperature of the part not exceed 125 °C under worst case operating conditions verified in the

end application.

4. I

sat1: Peak current for approximately 20% rolloff @ +25 °C

5. I

sat2: Peak current for approximately 20% rolloff @ +100 °C

6. I

sat3: Peak current for approximately 20% rolloff @ +125 °C

7. K-factor: Used to determine B

p-p for core loss (see graph).

p-p = K * L * ∆I * 10

-3

. B

p-p:(Gauss), K: (K-factor from table),

L: (Inductance in nH), ∆I (Peak to peak ripple current in Amps).

8. Part Number Definition: FP0707Rx-Rxxx-R

FP0707R= Product code and size

x= Version indicator

-Rxxx= Inductance value in μH, R= decimal point

-R suffix = RoHS compliant

Dimensions (mm)

Part marking: 0707Rx (x = Version indicator), Rxxx = Inductance value in uH (R = decimal point), wwllyy = date code, R = revision level

Tolerances are ±0.15 millimeters unless stated otherwise.

All soldering surfaces to be coplanar within 0.1 millimeter

DCR measured from point “a” to point “b”

Do not route traces or vias underneath the inductor

FP0707R1-R110-R 数据表(PDF) 2 Page - Eaton All Rights Reserved.

FP0707R1-R110-R 数据表(HTML) 2 Page - Eaton All Rights Reserved.

Html Pages

1 2 3 4 5

数据表下载