97SD3232

21

All data sheets are subject to change without notice

©2005 Maxwell Technologies

All rights reserved.

1 Gb (8-Meg X 32-Bit X 4-Banks) SDRAM

01.11.05 Rev 2

Write Operation: Burst write or single write mode is selected by the OPCODE (BA1, BA0, A12, A11, A10,

A9, A8) of the mode register.

1. Burst write: A burst write operation is enabled by setting OPCODE (A9, A8) to (0, 0). A burst write starts

in the same clock as a write command set. (The latency of data input is 0 clock.) The burst length can be set

to 1, 2, 4, or 8, like burst read operations. The write start address is specified by the column address and the

bank select address (BA0/BA1) at the write command set cycle.

2. Single write: A single write operation is enabled by setting OPCODE ( A9, A8) to (1, 0). In a single write

operation, data is only written to the column address and the bank select address (BA0/BA1) specified by

the write command set cycle without regard to the burst length setting. ( The latency of data input is 0 clock.)