requirements as specified in the user manual. If any of these specifications are exceeded in the final

product, a submission must be made to a notified body for compliance testing to all required standards.

Important: 

The 'CE' marking must be affixed to a visible location on the OEM product. The CE mark shall

consist of the initials "CE" taking the following form:

•

The CE marking must have a height of at least 5mm except where this is not possible on

account of the nature of the apparatus.

•

The CE marking must be affixed visibly, legibly, and indelibly.

More detailed information about CE marking requirements you can find at "DIRECTIVE

1999/5/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL" on 9 March 1999 at

section 12.

6.3.

Canada (IC)

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the

following two conditions: (1) this device may not cause interference, and (2) this device must accept any

interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts

de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire

de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le

brouillage est susceptible d'en compromettre le fonctionnement.

This equipment complies with radio frequency exposure limits set forth by Industry Canada for an

uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm

between the device and the user or bystanders.

Cet équipement est conforme aux limites d'exposition aux radiofréquences définies par Industrie Canada

pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de

20cm de distance entre le dispositif et l'utilisateur ou des tiers

Important: 

Any changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

6.4.

List of Antennas Tested With This Product

Table 6-1. List of Tested Antennas

Antenna number Make

Model/part #

Antenna gain [dBi] Type of antenna

Antenna 1

Johanson Technology 2450AT18D0100 1.5dBi

Ceramic Antenna

Antenna 2

Techfun Co., Ltd

M01-SS2

0dBi

External Antenna

Atmel SAM R21 Xplained Pro [USER GUIDE]

Atmel-42243D-SAM-R21-Xplained-Pro_User Guide-04/2016

21