LP6480-01

Apr.-2017

www.lowpowersemi.com

Page 9 of 10

Preliminary Datasheet

LP6480

Thermal Calculations

There are three types of losses associated with the LP6480

step-down converter: switching losses, conduction losses,

and quiescent current losses. Conduction losses are

switching devices. Switching losses are dominated by the

gate charge of the power output switching devices.

At full load, assuming continuous conduction mode (CCM), a

simplified form of the losses is given by:

is used to estimate the full load step-down converter switching

losses.

For the condition where the step-down converter is in dropout

at 95% duty cycle, the total device dissipation reduces to:

with input voltage, the total losses should be investigated over

the complete input voltage range. Given the total losses, the

for the SOP8 package which is 90℃/W.

Layout Guidance

When laying out the PC board, the following layout guideline

should be followed to ensure proper operation of the LP6480:

1. The power traces, including the GND trace, the SW trace

and the IN trace should be kept short, direct and wide to allow

large current flow. The L connection to the SW pins should be

as short as possible. Use several VIA pads when routing

between layers.

possible to VIN (Pin 5) and GND to get good power filtering.

3. Keep the switching node, SW (Pins 6) away from the

sensitive FB/OUT node.

4. The feedback trace or OUT pin should be separate from

any power trace and connect as closely as possible to the

load point. Sensing along a high-current load trace will

degrade DC load regulation.

closely as possible. The connection of L to the SW pin should

be as short as possible and there should not be any signal

lines under the inductor.

6. The resistance of the trace from the load return to PGND

should be kept to a minimum. This will help to minimize any

error in DC regulation due to differences in the potential of the

internal signal ground and the power ground.