9.2.2 Noninverting Gain of 3 V/V

The OPAx607 devices are normally stable in noise gain configurations (see SBOA066) of greater than 6 V/V

when conventional feedback networks are used, which is discussed in Section 8.3.4. The OPAx607 devices can

be configured in noise gains of less than 6 V/V by using capacitors in the feedback path and between the inputs

to maintain the desired gain at lower frequencies and increase the gain greater that 6 V/V at higher frequencies

such that the amplifier is stable. Configuration (a) in Figure 9-6 shows OPAx607 devices configured in a gain of 3

V/V by using capacitors and resistors to shape the noise gain and achieve a phase margin of approximately 56°

that is very close to the phase margin achieved for the conventional 6 V/V configuration (b) in Figure 9-6.

The key benefit of using a decompensated amplifier (such as the OPAx607) below the minimum stable gain, is

that it takes advantage of the low noise and low distortion performance at quiescent powers smaller than

comparable unity-gain stable architectures. By reducing the 100-pF input capacitor, higher closed-loop

bandwidth can be achieved at the expense of increased peaking and reduced phase margin. Ensure that low

parasitic capacitance layout techniques on the IN– pin are as small as 1 pF to 2 pF of parasitic capacitance on

the inverting input, which will require tweaking the noise-shaping component values to get a flat frequency

response and the desired phase margin. Configurations in Figure 9-6 does not take into account this parasitic

capacitance but it must be considered for practical purposes. Details on the benefits of decompensated

architectures are discussed in Using a decompensated op amp for improved performance. The one-capacitor,

externally compensated type method is used for noise gain shaping in the below circuit.

In a difference amplifier circuit, typically used for low side current sensing applications, the (noise gain) = (signal

gain + 1).

+5 V

0 V

+

±

2 k

2.5 pF

OPAx607

1 k

100 pF

(a) G = 3 V/V

+5 V

0 V

+

±

OPAx607

1 k

(b) G = 6 V/V

470

5 k

2.5 pF

+

±

+5 V

1NŸ

1NŸ

LOAD

GND

2 NŸ

2 NŸ

0V

2.5 pF

2.5 pF

GND

(c) G = 2 V/V

OPAx607

100 pF

470

Figure 9-6. Noninverting Gain of 3 V/V, 6 V/V Configurations and Difference Amplifier in Signal Gain of 2

V/V.

OPA607, OPA2607

SBOS981F – OCTOBER 2019 – REVISED SEPTEMBER 2020

www.ti.com

22

Submit Document Feedback

Copyright © 2020 Texas Instruments Incorporated

Product Folder Links: OPA607 OPA2607