Vicor Corp. Tel: 800-735-6200, 978-470-2900 Fax: 978-475-6715

V375C3V3C75B DC-DC Converter

Rev. 3

Page 2 of 8

Set your site on VICOR at www.vicorpower.com

Parameter

Min

Typ

Max

Unit

Notes

Operating input voltage

250

375

425

Vdc

Input surge withstand

500

Vdc

<100ms

Output voltage setpoint

3.267

3.3

3.333

Vdc

Nominal input; full load; 25°C

Output OVP setpoint

4.14

4.3

4.46

Vdc

25°C; recycle input voltage to restart ( 1 minute off )

Output power

75

Watts

At 100°C baseplate temperature

Efficiency

77

79

%

Nominal input; 75% of full load; 25°C

Parameter

Min

Typ

Max

Unit

Notes

Line regulation

±0.02

±0.4

%

Low line to high line; full load

Load regulation

±0.06

±0.4

%

No load to full load; nominal input

Temperature regulation

±0.002

±0.005

% / °C

Over operating temperature range

Ripple and noise, p-p

94

118

mV

Nominal input; full load; 20 MHz bandwidth

Current limit

23.1

24.6

30.6

Amps

Output voltage 95% of nominal

Short circuit current

15.8

24.6

30.6

Amps

Output voltage <250mV

Power sharing accuracy

±2

±5

%

10 to 100% of full load

Programming range

10

110

%

Of nominal output voltage. For trimming below 90%

of nominal, a minimum load of 10% of maximum

rated power may be required.

Parameter

Min

Typ

Max

Unit

Notes

Undervoltage turn-on

242.5

247.5

Vdc

Undervoltage turn-off

204.7

212.2

Vdc

Overvoltage turn-off/on

429.2

446.3

467.5

Vdc

Dissipation, standby

3.9

5.9

Watts

No load

MODULE OPERATING SPECIFICATIONS

MODULE INPUT SPECIFICATIONS

MODULE OUTPUT SPECIFICATIONS

ELECTRICAL CHARACTERISTICS

Electrical characteristics apply over the full operating range of input voltage, output load (resistive) and baseplate temperature,

unless otherwise specified. All temperatures refer to the operating temperature at the center of the baseplate.

Baseplate

Slotted (Style 1)

Slotted baseplate (style 1) requires no designator.

For threaded baseplate add a "2" to the end of the

part number. For thru-hole add a "3".

Pin style

Short (Style 1)

For long pin configuration add “L” to the end of the

part number. See page 7 for pin dimensions.

MODULE MECHANICAL SPECIFICATIONS

Note: For important information relative to applications where the converter modules are subject to continuous dynamic loading,

contact Vicor applications engineering at 800-927-9474.