OPA607 datasheet(10/45 Pages) TI

10 / 45 page

7.5 Electrical Characteristics (continued)

At TA = 25°C, VS = 2.2 V to 5.5 V, G = 6 V/V(4), RF = 5 kΩ, CF = 2.5 pF, VCM = (VS / 2) – 0.5 V, CL = 10 pF,

RL = 10 kΩ

connected to (VS / 2) – 0.5 V, and, PD connected to (VS+) (unless otherwise noted)(1)

PARAMETER

TEST CONDITIONS

MIN

TYP

MAX

UNIT

OUTPUT

Output voltage swing from supply rails

TA = – 40℃ to +125℃

ISC

Output Short-circuit current

Open-loop output impedance

f = 1 MHz

500

POWER SUPPLY

Quiescent current per amplifier

IO = 0 mA

900

1100

µA

IO = 0 mA, TA = –40°C to +125°C

1200

POWER DOWN (Device Enabled When Floating)

Power Down quiescent current per

amplifier(3)

PD = VS–

750

1000

Power Down pin bias current per

amplifier(6)

PD = VS–

–750

–1000

Enable voltage threshold

Logic-High threshold

0.7 x VS

Disable voltage threshold

Logic-Low threshold

0.2 x VS

tON

Turn-on time delay(2)

µs

tOFF

Turn-off time delay

0.5

(1)

Parameters with minimum or maximum specification limits are 100% production tested at 25ºC, unless otherwise noted. Over

temperature limits are based on characterization and statistical analysis.

(2)

Specified by design and characterization or both ; not production tested.

(3)

In Power Down mode current drawn by the opamp is equal to the bias current sourced on the PD pin

(4)

All Gains (G) mentioned are in V/V unless otherwise noted.

(5)

Lowpass-filter bandwidth is 92kHz for f = 20 kHz and 20 kHz for f = 1 kHz.

(6)

Negative value of the Power Down bias current indicates current being sourced from the opamp's PD pin towards external circuit.

OPA607, OPA2607

SBOS981I – OCTOBER 2019 – REVISED FEBRUARY 2021

www.ti.com

Submit Document Feedback

Product Folder Links: OPA607 OPA2607

OPA607 数据表(PDF) 10 Page - Texas Instruments

OPA607 数据表(HTML) 10 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45

数据表下载