MODEL: 10JPA

http://www.m-system.co.jp/

10JPA SPECIFICATIONS

ES-0873 Rev.11 Page 2/3

Screw terminal: Nickel-plated steel

Housing material: Flame-resistant resin (black)

Isolation: Input to output 1 to output 2 to power

Overrange output: -10 – +120 % at 1 – 5 V

(0 – 120 % when 0 % input equals to 0 Hz.)

Linearization: 16 points max. represented as percentage of

full-scale

Adjustments: Programming Unit (model: PU-2x); input

range, low-end cutout, zero and span, simulating output,

averaging nonuniform pulses, linearization data, etc.

(Refer to the users manual of JXCON for the adjustments

configurable with JXCON.)

Low-end cutout: 0 – 100 % adjustable (factory set to 0 %);

hysteresis fixed to 1 %

INPUT SPECIFICATIONS

Excitation: 12 V DC @30 mA; shortcircuit protection

Pulse width (time) requirement: 10 msec. min. at

< 20 Hz; duty ratio 20 – 80 % at ≥ 20 Hz

Offset: Max. 3 times span

■ Open Collector

Frequency range: 0 – 0.01 Hz through 25 kHz

(0 – 1 kHz will be used if not otherwise specified)

Sensing: Approx. 12 V DC @ 3 mA

ON/OFF level: ≤ 800 Ω / 2 V for ON,

≥ 1.2 kΩ / 3.6 V for OFF

■ Mechanical Contact

Frequency range: 0 – 0.01 Hz through 5 Hz

(0 – 5 Hz will be used if not otherwise specified)

Sensing: Approx. 12 V DC @ 3 mA

ON/OFF level: ≤ 800 Ω / 2 V for ON,

≥ 1.2 kΩ / 3.6 V for OFF

■ Voltage Pulse: Square or sine waveforms

Frequency range: 0 – 0.01 Hz through 25 kHz

(0 - 1 kHz will be used if not otherwise specified.)

Input amplitude: 2 – 50 Vp-p

Input impedance: 10 kΩ min.

INSTALLATION

Current consumption: Approx. 60 mA with voltage output 1

Approx. 90 mA with current output 1

Operating temperature: -5 to +55°C (23 to 131°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Mounting: Standard Rack 10BXx

Weight: 220 g (0.49 lb)

PERFORMANCE in percentage of span

Accuracy: ±0.1 % with segment gain ≤ 1 [±0.1 % × gain]

with segment gain > 1

Temp. coefficient: ±0.015 %/°C (±0.008 %/°F)

Response time: 0.5 sec. + 1 pulse cycle (0 – 90 %)

Line voltage effect: ±0.1 % over voltage range

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 500 V AC @ 1 minute

(input to output 1 to output 2 to power)

1500 V AC @ 1 minute (input or output or power to ground)