MODEL: 10AP

10AP SPECIFICATIONS

ES-0851 Rev.9 Page 2/3

http://www.m-system.co.jp/

OUTPUT SPECIFICATIONS

■ Open Collector: 30 V DC @ 100 mA (resistive load)

Frequency range: 0 – 10 pulses/hour through 1 kHz

Saturation voltage: 0.6 V DC

When output 1 is photo MOSFET relay pulse, a timer for

output 2 is provided, which limits ON time within 75

±25msec.

■ 5 V Pulse

Frequency range: 0 – 10 pulses/hour through 1 kHz

Hi level: 3.0 – 5.5 V

Lo level: ≤ 0.5 V

Load resistance: 250 Ω min.

■ Photo MOSFET Relay Pulse

Frequency range: 0 – 10 pulses/hour through 30 Hz

Timer: Limits ON time within 75 ±25 msec.

Rating: 132 V AC @ 200 mA (cos ø = 1)

30 V DC @ 200 mA (resistive load)

ON resistance: ≤ 2 Ω

OUTPUT PULSE WIDTH

• Open Collector

• Voltage Pulse

OFF

ON

20%

80%

1 / f

■ Frequency less than 500 Hz at 100% input

➞ Duty ratio 20% (See the figure below)

• OUTPUT 2’s Open Collector and Photo MOSFET

Relay Pulse

OFF

ON

20%

80%

1 / f

H Level

L Level

20%

80%

1 / f

• Open Collector

• Voltage Pulse

■ Frequency greater than 500 Hz at 100% input

➞ See the figure and equation below.

H Level

L Level

Pulse Width

OFF

ON

Pulse Width

Pulse Width [millisec.] =

1

2.09 × 100% Frequency [kHz]

■ When OUTPUT 1 is Photo MOSFET Relay Pulse

➞ See the figure below. ON pulse width is limited

within 75 ±25 msec. when the output frequency

gets low (below 2 to 4 Hz).

INSTALLATION

Current consumption: Approx. 60 mA

Operating temperature: -5 to +55°C (23 to 131°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Mounting: Standard Rack 10BXx

Weight: 200 g (0.44 lb)

PERFORMANCE in percentage of span

Accuracy: ±0.1 %

Temp. coefficient: ±0.015 %/°C (±0.008 %/°F)

Response time: Approx. 3 sec. (0 – 90 %)

Line voltage effect: ±0.1 % over voltage range

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 500 V AC @ 1 minute

(input to output 1 to output 2 to power)

1500 V AC @ 1 minute (input or output or power to ground)