MODEL: FSP

FSP SPECIFICATIONS

ES-1456 Rev.11 Page 2/3

http://www.m-system.co.jp/

Pulse width time requirement: 20 μsec. min. for ON and OFF

Sensing: Approx. 12 V DC @3 mA

ON/OFF level: ≤ 200 Ω / 0.6 V for ON, ≥ 100 kΩ / 6 V for OFF

■ Voltage Pulse: Square or sine waveforms

Pulse width time requirement: 20 μsec. min. for high and

low levels

Hi level: 2 – 50 V

Lo level: ≤ 1 V

Input impedance: 10 kΩ min.

OUTPUT SPECIFICATIONS

■ DC Current: 0 – 20 mA DC

Minimum span: 1 mA

Offset: Max. 1.5 times span

Load resistance: Output drive 15 V max.

■ DC Voltage: 0 – 12 V DC

Minimum span: 5 mV

Offset: Max. 1.5 times span

Load resistance: Output drive 1 mA max.; at ≥ 0.5 V

INSTALLATION

Power input

•AC: Approx. 5.5 VA

•DC: 24 V approx. 85 mA

110 V approx. 25 mA

Operating temperature: -5 to +55°C (23 to 131°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Mounting: Surface or DIN rail; Standard Rack Mounting

Frame BX-16H available

Weight: 200 g (0.44 lb)

PERFORMANCE in percentage of span

Accuracy: ±0.1 % (output 10 – 100 %)

Temp. coefficient: ±0.015 %/°C (±0.008 %/°F)

Response time: (0 – 90%)

Approx. 1.8 sec. with 0 – 50 Hz

Approx. 0.7 sec. with 0 – 100 Hz

Approx. 0.5 sec. with 0 – 500 Hz

Approx. 0.5 sec. with 0 – 10 kHz

Ripple: 0.2 %p-p max. with input ≥ 10 %

Line voltage effect: ±0.1 % over voltage range

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength

Power input code R:

1000 V AC @ 1 minute (input to output)

2000 V AC @ 1 minute (input or output or power to ground)

500 V AC @ 1 minute (I/O to power)

Power input code K, L, P:

1000 V AC @ 1 minute (input to output)

2000 V AC @ 1 minute (input or output or power to ground)

1500 V AC @ 1 minute (I/O to power)