MODEL: M2XF2

M2XF2 SPECIFICATIONS

ES-5085 Rev.12 Page 1/5

http://www.m-system.co.jp/

Super-mini Signal Conditioners Mini-M Series

LINEARIZER

(PC programmable)

Functions & Features

• Accepting non-linear input and providing a linearized

output, proportional to the process variables

• 100-point calibration

• PC programmable

Typical Applications

• V-notch weir

• Gas analyzer

• Irregular-shaped tank level input for volume calculation

• Square root extracting for DP transmitter

Model

23 (.91)

76

(2.99)

mm (inch)

124

(4.88)

MODEL: M2XF2–[1][2]–[3][4]

ORDERING INFORMATION

• Code number: M2XF2-[1][2]-[3][4]

Specify a code from below for each [1] through [4].

(e.g. M2XF2-S2Z1-R/CE/Q)

• Input range (e.g. 1 – 5 V DC)

• Output range (e.g. 4 – 20 mA DC)

• Specify the specification for option code /Q

(e.g. /C01/S01/SET)

[1] INPUT

Current

Z1: Range 0 – 50 mA DC (Input resistance 100 Ω)

Voltage

S1: Range -1 – +1 V DC (Input resistance 1 MΩ min.)

S2: Range -10 – +10 V DC (Input resistance 1 MΩ min.)

(Configurator software is used to change input over the

described range of the selected suffix code. For changing

out of this range (between S1 and S2), set the Input Range

Selector on the side of unit before software adjustment.

For a current input, set the Selector to the same setting as

for S2 and use a receiving resistor.)

[2] OUTPUT

Current

Z1: Range 0 – 20 mA DC

Voltage

V1: Range -2.5 – +2.5 V DC

V2: Range -10 – +10 V DC

(Configurator software is used to change output over the

described range of the selected suffix code. For changing

out of this range, set the Output Range Selectors inside the

unit before software adjustment.)

[3] POWER INPUT

AC Power

M2: 100 – 240 V AC (Operational voltage range 85 – 264 V,

47 – 66 Hz)

(90 – 264 V for UL)

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

P: 110 V DC

(Operational voltage range 85 – 150 V, ripple 10 %p-p max.)

(110 V ±10 % for UL)

[4] OPTIONS (multiple selections)

Standards & Approvals (must be specified)

/N: Without CE or UL

/CE: CE marking

/UL: UL approval, CE marking

Other Options

blank: none

/Q: Option other than the above (specify the specification)

SPECIFICATIONS OF OPTION: Q (multiple selections)

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating (UL not available)

TERMINAL SCREW MATERIAL

/S01: Stainless steel (UL not available)

EX-FACTORY SETTING

/SET: Preset according to the Ordering Information Sheet

(No. ESU-5085)

RELATED PRODUCTS

• PC configurator software (model: JXCON)

Downloadable at M-System’s web site.

A dedicated cable is required to connect the module to the

PC. Please refer to the internet software download site or

the users manual for the PC configurator for applicable

cable types.