MODEL: M6SXAP

M6SXAP SPECIFICATIONS

ES-7996 Rev.4 Page 1/4

http://www.m-system.co.jp/

Tension-Clamp Ultra-Slim Signal Conditioners M6S Series

DC/FREQUENCY CONVERTER

(PC programmable)

Function & features

• Maintenance-free tension clamp connection

• 5.9-mm wide ultra-slim design

• Low profile allows the M6S module mounted in a 120-mm

deep panel

• Converts a DC input into a FM (frequency modulation) or

PWM (pulse width modulated) signal

• PC programmable

• High-density mounting

• Power and status indicator LEDs

5.9 (.23)

94

(3.70)

102

(4.02)

mm (inch)

MODEL: M6SXAP–[1][2]–R[3]

ORDERING INFORMATION

• Code number: M6SXAP-[1][2]-R[3]

Specify a code from below each [1] through [3].

(e.g. M6SXAP-Z1A-R/Q)

• Specify the specification for option code /Q

(e.g. /C01/SET)

[1] INPUT

Current

Z1: Range 0 – 50 mA DC (Input resistance 25 Ω)

Voltage

S1: Range -1000 – +1000 mV DC (Input resistance 1 MΩ min.)

S2: Range -10 – +10 V DC (Input resistance 1 MΩ min.)

(Configurator software is used to change the input type and

precise range.)

[2] OUTPUT

A: Open collector (100 kHz for FM, 1 kHz for PWM)

M: 5 V pulse (100 kHz for FM, 1 kHz for PWM)

N: 12 V pulse (100 kHz for FM, 1 kHz for PWM)

P: 24 V pulse (100 kHz for FM, 1 kHz for PWM)

Output modulation type and range are configurable with the

configure software. The output signal type is configurable

with the DIP switches.

POWER INPUT

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

[3] OPTIONS

blank: none

/Q: With options (specify the specification)

SPECIFICATIONS OF OPTION: Q (multiple selections)

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

EX-FACTORY SETTING

/SET: Preset according to the Ordering Information Sheet

(No. ESU-7837)

RELATED PRODUCTS

• PC configurator software (model: M6CFG)

Downloadable at M-System’s web site.

A dedicated cable is required to connect the module to the

PC. Please refer to the internet software download site or

the users manual for the PC configurator for applicable

cable types.

GENERAL SPECIFICATIONS

Connection

Input and output: Tension clamp

Power input: Via the Installation Base (model: M6SBS)

or Tension clamp

Housing material: Flame-resistant resin (black)

Isolation: Input to output to power

Zero adjustment: -2 to +2 % (PC programming)

Span adjustment: 98 to 102 % (PC programming)

Power LED: Green light turns on when the power is supplied.

Status indicator LED: Orange LED; Blinking patterns indicate

different operating status of the transmitter.

Programming: Downloaded from PC

• Input type and range

• Modulation type (FM, PWM)

• Output range

• Zero and span

• User’s linearization table (max. 101 points, specified