MODEL: MXCB

MXCB SPECIFICATIONS

ES-1745 Rev.8 Page 2/6

http://www.m-system.co.jp/

INPUT SPECIFICATIONS

■ Contact Input: TTL level (5V-CMOS level) or open

collector/dry contact (detecting voltage: approx. 5 V,

saturation voltage: ≤ 1 V, sink current: 0.5 mA)

• UP/DOWN/STOP signals (input from the computer)

UP/DOWN signal: Increases/decreases the analog output.

STOP signal: Switches AUTO/MAN modes.

• UP/DOWN signals (input from the Soft-Terminal):

Controls the analog output in MAN mode.

OUTPUT SPECIFICATIONS

■ DC Current: 0.0 – 20.0 mA DC

Operational range: 0.0 – 24.0 mA DC

Minimum increment: 0.1 mA

Default setting: 4.0 – 20.0 mA DC

■ DC Voltage

Code V1: -1.00 – +1.00 V DC

Operational range: -1.15 – +1.15 V DC

Minimum increment: 10 mV

Code V2: -10.0 – +10.0 V DC

Operational range: -11.5 – +11.5 V DC

Minimum increment: 100 mV

Note: Set to the 100 % output with a larger value than the

0 % output value.

Default setting:

Code V1: -1.00 – +1.00 V DC

Code V2: -10.0 – +10.0 V DC

INSTALLATION

Power consumption

•AC: Approx. 10 VA

•DC: Approx. 3.5 W (150 mA at 24 V)

Operating temperature: -5 to +55°C (23 to 131°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Mounting: Surface or DIN rail

Weight: 450 g (0.99 lb)

PERFORMANCE in percentage of max. span

Accuracy: ±0.1 %

Min. span required to ensure the accuracy: 20 % of the

nominal output range

Display accuracy: Accuracy ±1 digit

(with 0.0 – 100.0 scaling)

Temp. coefficient: ±0.015 %/°C (±0.008 %/°F)

Response time: Approx. 1 – 999 sec. variable (0 – 100 %)

memory)

Line voltage effect: ±0.1 % over voltage range

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 2000 V AC @1 minute (input to output

to power to ground)

STANDARDS & APPROVALS

EU conformity:

EMC Directive

EMI EN 61000-6-4

EMS EN 61000-6-2

Low Voltage Directive

EN 61010-1

Installation Category II

Pollution Degree 2

Input to output to power – Basic insulation (300 V)

RoHS Directive

EN 50581