MODEL: MXMS

MXMS SPECIFICATIONS

ES-1702 Rev.12 Page 1/3

http://www.m-system.co.jp/

Plug-in Signal Conditioners MX-UNIT

PROGRAMMED RAMP GENERATOR

(front configurable)

Functions & Features

• Generates various patterns of output by front UP-DOWN

key programming

• Upscale/downscale limits, output cycle can be

programmed

• Programming and display in engineering units

• Max. 16-point-segment ramps can be generated

• Loop test output

Typical Applications

• Parameters setting for computers and DCS

• Signals used in a panel, which are rarely changed

50

(1.97)

123

(4.84)

80

(3.15)

mm (inch)

MODEL: MXMS–[1]–[2][3]

ORDERING INFORMATION

• Code number: MXMS-[1]-[2][3]

Specify a code from below for each of [1] through [3].

(e.g. MXMS-V1-M2/Q)

• Specify the specification for option code /Q

(e.g. /C01/S01/SET)

[1] OUTPUT

Current

Z1: Range 0 – 20 mA DC (Load resistance 600Ω max.)

Voltage

V1: Range -1 – +1 V DC (Load resistance 1000Ω min.)

V2: Range -10 – +10 V DC (Load resistance 10kΩ min.)

[2] POWER INPUT

AC Power

M2: 100 – 240 V AC (Operational voltage range 85 – 264 V,

47 – 66 Hz)

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

P: 110 V DC

(Operational voltage range 85 – 150 V, ripple 10 %p-p max.)

[3] OPTIONS

blank: none

/Q: With options (specify the specification)

SPECIFICATIONS OF OPTION: Q (multiple selections)

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

TERMINAL SCREW MATERIAL

/S01: Stainless steel

EX-FACTORY SETTING

/SET: Preset according to the Ordering Information Sheet

(No. ESU-1702)

GENERAL SPECIFICATIONS

Construction: Plug-in

Connection: M3.5 screw terminals

Screw terminal: Chromated steel (standard) or stainless

steel

Housing material: Flame-resistant resin (black)

Isolation: Control I/O to output to power

Programming: Via front keys

• Scaled range

• Output range

• Output wave type and cycle

• etc...

(Refer to the instruction manual for details)

■ DISPLAY

LED: 8 mm (.31”) 7 segment, red

Number of display digits: 4 digits for DATA display; 2 digits

for ITEM display

Scaling: -9999 to 9999

MV indication: Output signal in engineering unit

Overrange indication: LEDs blinking

Power saving mode: Displays turn off if the keys are

untouched for a preset time period

LEDs: Red; the PL1 turns on with negative polarity and the

PL2 turns on during a program is running.

INPUT SPECIFICATIONS

■ Output Enable Command

Minimum ON time: 0.1 sec. (Prevent chattering.)

Sensing voltage: 5 V DC

ON/OFF levels: ≤ 500 Ω / ≤ 0.65 V for ON;

≥ 30 kΩ / 4.5 V for OFF