MODEL: PTPH

PTPH SPECIFICATIONS

ES-1306 Rev.5 Page 2/3

http://www.m-system.co.jp/

Span adjustment: 95 to 105 % (front)

Adjustable individually for each output 1 and output 2.

Indicator LED: Red light blinks in 800 millisecond intervals

when the power is supplied; blinks in 200 millisecond

intervals when the peak hold output is reset.

Function setting: DIP switch

• Output 2 Function (Momentary value output/Peak hold

value output)

• Line Frequency

• Response Time

Reset control: Used to reset the peak hold output.

Momentary value is output immediately after the resetting.

INPUT SPECIFICATIONS

■ VOLTAGE INPUT

Frequency: 50 or 60 Hz

Input burden: ≤ 0.5 VA

Overload capacity: 200 % of rating for 1 minute, 120 %

continuous

Operational range: 0 – 120 % of rating

■ Contact Input: Used to reset the peak hold output.

Momentary value is output immediately after the resetting.

Detecting voltage/current: 15 V DC / approx. 2.5 mA

Detection levels: ≤ 5 kΩ, ≤ 6 V for ON;

≥ 100 kΩ, ≥ 14 V for OFF

INSTALLATION

Power Consumption

•AC:

Approx. 5 VA at 100 V

Approx. 6 VA at 200 V

Approx. 7 VA at 240 V

•DC: Approx. 3 W

Operating temperature: -5 to +60°C (23 to 140°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Mounting: Surface or DIN rail

Weight: 210 g (0.46 lb)

PERFORMANCE in percentage of span

Accuracy: ±0.5 %

Temp. coefficient: ±0.03 %/°C (±0.02 %/°F)

Response time: ≤ 50/100/200/500 msec. (0 – 90 %)

Peak hold reset time: 20 msec.

Ripple: 0.5 %p-p max.

Line voltage effect: ±0.1 % over voltage range

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 2000 V AC @ 1 minute

(input to output 1 or output 2 or contact input to power to

ground)

500 V AC @ 1 minute (output 1 to output 2 to contact input)

Impulse withstand voltage: 1.2/50 μsec., ±5 kV (input to

output 1 or output 2 or contact input or ground)

STANDARDS & APPROVALS

EU conformity:

EMC Directive

EMI EN 61000-6-4

EMS EN 61000-6-2

Low Voltage Directive

EN 61010-1

Measurement Category II (input)

Installation Category II (power)

Pollution Degree 2

Contact input or output to power: Reinforced insulation

(300 V)

Input to output: Reinforced insulation (300 V)

Input to contact input or power: Basic insulation (300 V)

RoHS Directive

EN 50581