MODEL: W2XF

W2XF SPECIFICATIONS

ES-5507 Rev.4 Page 1/4

http://www.m-system.co.jp/

Space-saving Dual Output Signal Conditioners

Mini-MW Series

LINEARIZER

(PC programmable)

Functions & Features

• Accepting non-linear input and providing a linearized

output, proportional to the process variables

• 101-point calibration

• PC programmable

• High-density mounting

Typical Applications

• V-notch weir

• Gas analyzer

• Irregular-shaped tank level input for volume calculation

• Square root extracting for DP transmitter

88.5

(3.48)

29.5 (1.16)

124

(4.88)

mm (inch)

MODEL: W2XF–[1][2][3]-[4][5]

ORDERING INFORMATION

• Code number: W2XF-[1][2][3]-[4][5]

Specify a code from below for each [1] through [5].

(e.g. W2XF-S2Z1V3-M2/N/Q)

• Input range (e.g. 1 – 5 V DC)

• Output 1 range (e.g. 4 – 20 mA DC)

• Output 2 range (e.g. 1 – 5 V DC)

• Specify the specification for option code /Q

(e.g. /C01/S01/SET)

Note: If one of the outputs should be a current range,

specify it for the Output 1 to allow a greater load.

[1] INPUT

Current

Z1: Range 0 – 50 mA DC (Input resistance 24.9 Ω)

Voltage

S1: Range -1 – +1 V DC (Input resistance 1 MΩ min.)

S2: Range -10 – +10 V DC (Input resistance 1 MΩ min.)

(Configurator software is used to change the input type and

precise range.)

[2] OUTPUT 1

Current

Z1: Range 0 – 20 mA DC

Voltage

V2: Range -10 – +10 V DC

V3: Range -5 – +5 V DC

[3] OUTPUT 2

Same range availability as Output 1

Y: None

(Configurator software is used to change output over the

described range of the selected suffix code.

For changing between suffix codes, set the Output Range

Selector on the side of unit before software adjustment.)

[4] POWER INPUT

AC Power

M2: 100 – 240 V AC (Operational voltage range 85 – 264 V,

47 – 66 Hz)

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

[5] OPTIONS (multiple selections)

Standards & Approvals (must be specified)

/N: Without CE

Other Options

blank: none

/Q: Option other than the above (specify the specification)

SPECIFICATIONS OF OPTION: Q (multiple selections)

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

TERMINAL SCREW MATERIAL

/S01: Stainless steel

EX-FACTORY SETTING

/SET: Preset according to the Ordering Information Sheet

(No. ESU-5507)

RELATED PRODUCTS

• PC configurator software (model: W2CFG)

Downloadable at M-System’s web site.

A dedicated cable is required to connect the module to the

PC. Please refer to the internet software download site or

the users manual for the PC configurator for applicable