MODEL: SVA

SVA SPECIFICATIONS

ES-1309 Rev.6 Page 2/3

http://www.m-system.co.jp/

GENERAL SPECIFICATIONS

Construction: Plug-in

Connection: M3.5 screw terminals

Screw terminal: Chromated steel (standard) or stainless

steel

Housing material: Flame-resistant resin (black)

Isolation: Input to output to power

Overrange output: 0 mA or 0 V up to 105 % of upper range

value

Zero adjustment: -25 – +25 % no output below 0 mA or 0 V

(front)

Span adjustment: 50 to 100 % for the rated input span

(front)

INPUT SPECIFICATIONS

■ DC Current:

Shunt resistor attached to the input terminals (0.5 W)

Specify input resistance value for code Z.

■ DC Voltage: -30 – +30 V DC

Span: Min. 3 mV, max. 30 V

Offset: Max. 1.5 times span

Input resistance

Span 3 – 10 mV : ≥ 10 kΩ

Span 10 – 100 mV : ≥ 10 kΩ

Span 0.1 – 1 V : ≥ 100 kΩ

Span ≥ 1 V : ≥ 1 MΩ

OUTPUT SPECIFICATIONS

■ DC Current: 0 – 200 mA DC

Minimum span: 20 mA

Zero suppression: max. 30 % of span

Load inductance: 1 H max.

Load resistance

Max. current ≤ 100 mA: Output drive max. 20 V

■ DC Voltage: 0 – 20 V DC

Minimum span: 2 V

Zero suppression: Max. 30 % of span

Load resistance

[W]

INSTALLATION

Power consumption

•AC: Approx. 10 VA, 5 W max.

•DC: ≤ 5 W

Operating temperature: -5 to + 50°C (23 to 122°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Mounting: Surface or DIN rail

Weight: 300 g (0.66 lb)

PERFORMANCE in percentage of span

Accuracy: ±0.2 %

Temp. coefficient: ±0.02 %/°C (±0.01 %/°F)

Response time: ≤ 0.5 sec. (0 – 90 %)

Load effect

Current output: ±0.2 % over load range

Voltage output: +0.2 % or -{0.2 + (0.3 [Ω] × max. load

[A]) / output span [V] × 100} % over load range

Line voltage effect: ±0.2 % over voltage range

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 2000 V AC @1 minute (input to output

to power to ground)

STANDARDS & APPROVALS

EU conformity:

EMC Directive

EMI EN 61000-6-4

EMS EN 61000-6-2

Low Voltage Directive

EN 61010-1

Measurement Category II

Pollution Degree 2

Input or output to power: Reinforced insulation (300 V)

Input to output: Basic insulation (300 V)

RoHS Directive

EN 50581