© Semiconductor Components Industries, LLC, 2020

March, 2021 − Rev. 1

1

Publication Order Number:

EVBUM2775/D

EVBUM2775/D

Compact Intelligent Power

Module (IPM) Motor Control

Development Kit (MDK)

1 kW

This User Guides refer to revision 0.4 of the

SECO−1KW−MCTRL−GEVK evaluation board.

Description

This user guide provides practical guidelines for compact

Intelligent Power Module (IPM) evaluation board with

interleaved

power

factor

Correction

(PFC)

SECO−1KW−MCTRL−GEVB including its main features

and key data. The board is fully compatible with the

Universal Controller Board (UCB), based on the Xilinx

Zynq−7000 SoC, which embeds FPGA logic and two ARM

Cortex−A9 processors. As such, the system is fit for

high−end control strategies and enables operation of a

variety of motor technologies (AC induction motor, PMSM,

BLDC, etc.). The board was developed to support customers

during their first steps designing application with IPM and

PFC. The design was tested as described in this document

but not qualified regarding safety requirements or

manufacturing and operation over the whole operating

temperature range or lifetime. The board is intended for

functional testing under laboratory conditions and by

trained specialists only.

Collateral

• SECO−1KW−MCTRL−GEVB

• Universal Controller Board (UCB)

• NFAQ1060L36T

• NCP1632

• FCPF125N65S3

• NCP1063

• NCS2003

• NCS2250

Features

supply 230 Vrms

±15 %, EMI filter, 2−channel

interleaved Power Factor Correction (PFC)

FPGA−controller based on Xilinx Zynq− 7000 SoC

for rapid evaluation

containing an inverter power stage for a high voltage

3−phase inverter in a DIP−S3 package

NMOS power transistors and FFSPF1065A diodes

15VDC – non−isolated buck converter using NCP1063

operational amplifier

Attention: The SECO−1kW−MCTRL−GEVB is powered by AC Mains, and exposed to high voltage. Only trained

personnel should manipulate and operate on the system. Ensure that all boards are properly connected before

powering, and that power is off before disconnecting any boards. It is mandatory to read the Safety Precautions

section before manipulating the board. Failure to comply with the described safety precautions may result in

personal injury or death, or equipment damage.

www.onsemi.com

EVAL BOARD USER’S MANUAL