Zhengzhou Winsen Electronics Technology Co.,Ltd.

www.winsen-sensor.com

TEL:+86-371-67169097 /67169670

Email: sales@winsensor.com

Leading gas sensing solutions supplier in China!

Application instruction

External interface of ZP06 VCC, GND, S(PCB Silk print).

VCC, GND connects to vehicle power supply; S is output of working status.

S is the state output for the module:

In normal working state: S is high level

In failure state: S is low level

In alarm state: Output is 1Hz wave which occupies 50% ratio

ZP06

electric power lamp, fault lamp, alarm lamp.

Instructions of LED lamp status:

Normal status : Green lamp flickers once every three seconds.

Fault status: Yellow lamp keeps light.

Alarm status: Red lamp flickers once every second.

Cautions

1 .Following conditions must be prohibited

1.1 Exposed to organic silicon steam

Module will lose sensitivity and never recover if it absorbs organic silicon steam. Module

must avoid exposing to silicon bond, fixature, silicon latex, putty or plastic contain silicon

environment.

1.2 High Corrosive gas

If the module is exposed to high concentration corrosive gas (such as H

etc.), it will not only result in corrosion of sensor’s heating material and pins, also it

causes sensitivity and performance attenuation.

1.3 Touch water

Sensitivity of the sensors will be reduced when spattered or dipped in water.

1.4 Freezing

Do avoid icing on sensor’s surface, otherwise sensing material will be broken and lost

sensitivity.

2 .Following conditions must be avoided

2.1 Water Condensation

Indoor conditions, slight water condensation will influence sensors’ performance lightly.

However, if water condensation on sensing material surface and keep a certain period,

sensors’ sensitive will decrease.

2.2 Used in high gas concentration

No matter the sensor is electrified or not, if it is placed in high gas concentration for long

time, sensors characteristic will be affected. If lighter gas sprays the sensor, it will cause

extremely damage.

2.3 Long time storage

The sensors resistance will drift reversibly if the module is stored for long time without

electrify, this drift is related with storage conditions. Modules should be stored in airproof

bag without volatile silicon compound. For the modules with long time storage but no

electrify, they need long galvanical aging time for stability before using. The suggested