Zhengzhou Winsen Electronics Technology Co., Ltd

www.winsen-sensor.com

Tel: 86-371-67169097/67169670

Fax: 86-371-60932988

Email: sales@winsensor.com

Leading gas sensing solutions supplier in China!

Fig7.long-term Stability of MP901

Cautions

1 .Following conditions must be prohibited

1.1 Exposed to volatilizable organic silicon steam

Sensing material will lose sensitivity and never recover if the sensor absorbs organic silicon steam. Sensors

must avoid exposing to silicon bond, fixature, silicon latex, putty or plastic contain silicon environment.

1.2 High Corrosive gas

If the sensors are exposed to high concentration corrosive gas (such as H

result in corrosion of sensors structure, also it cause sincere sensitivity attenuation.

1.3 Alkali, Alkali metals salt, halogen pollution

The sensors performance will be changed badly if sensors be sprayed polluted by alkali metals salt especially

brine, or be exposed to halogen such as fluorine.

1.4 Touch water

Sensitivity of the sensors will be reduced when spattered or dipped in water.

1.5 Freezing

Do avoid icing on sensor’s surface, otherwise sensing material will be broken and lost sensitivity.

1.6 Applied higher voltage

Applied voltage on sensor should not be higher than stipulated value, even if the sensor is not physically

damaged or broken, it causes down-line or heater damaged, and bring on sensors’ sensitivity characteristic

changed badly.

1.7 Voltage on wrong pins

As Fig8,Pin 1connects to heater(or test) power supply, Pin 2 connects to load resistance, Pin 3 connects

ground.;

Fig8. Pins Schematic Diagram

3

2

1

Time (day)

Output Voltage (V)