MODEL: 40DCT

40DCT SPECIFICATIONS

ES-9538 Rev.8 Page 2/7

https://www.m-system.co.jp/

values out of the display range. 'S.ERR' blinks surpassing

the permissible range. 'ERR' blinks when input scaling

setting is inappropriate.

Engineering unit indication: Sticker label attached

DC, AC, mV, V, kV, μA, mA, A, kA, mW, W,

kW, var, kvar, Mvar, VA, Hz, Ω, kΩ, MΩ,

cm, mm, m, m/sec, mm/min, cm/min, m/min,

N, kN, Pa, kPa, MPa, t, t/h, ℃, °F, %RH, J,

kJ, MJ, rpm, sec, min, pH, %, ppm, etc.

INPUT SPECIFICATIONS

■ AC Input

Frequency: 40 - 100 Hz; 45 – 65 Hz for input code A4 and A5

Overload capacity: 500 % of rating for 3 sec., 200 % for 10

sec., 120 % continuous

Input burden:

A1: 0.002 VA

A2: 0.02 VA

A3: 0.2 VA

A4: 0.1 VA

A5: 0.5 VA

■ Hold Input: Dry contact input

Detecting level: ≤ 1.5 V

Sensing: Approx. 5 V DC, 1 mA

INSTALLATION

Power consumption

•AC:

≤ 3.0 VA for 100 – 120 V

≤ 4.2 VA for 200 – 240 V

•DC: ≤ 1.0 W

Operating temperature: -10 to +55°C (14 to 131°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Mounting: Panel flush mounting

Weight: 180 g (0.40 lb)

PERFORMANCE

Input accuracy:

A1 to A3: ±0.4% rdg ±1digit,

(< 35 % of full scale: ±0.4% FS ±1digit)

A4 to A5: ±0.4% FS ±1digit

Temp. coefficient: ±0.015 %/°C (±0.008 %/°F)

Line voltage effect: ±0.2 % over voltage range

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 2000 V AC @ 1 minute

(input to power to ground)

STANDARDS & APPROVALS

EU conformity:

EMC Directive

EMI EN 61000-6-4

EMS EN 61000-6-2

Low Voltage Directive

EN 61010-1

Measurement Category I (input)

Installation Category II (power)

Pollution degree 2

Input to power: Reinforced insulation (300 V)

RoHS Directive