MODEL: 40DPT

40DPT SPECIFICATIONS

ES-9537 Rev.7 Page 2/7

https://www.m-system.co.jp/

DISPLAY

Display: 4 digits of 20.3 mm (0.8 inch) height, 7-segment,

red LED

Display range: -9999 to 9999

Scaling range: -9999 to 9999 counts

Zero indication: Higher-digit zeros are suppressed.

Over-range indication: '-9999' or '9999' blinking for display

values out of the display range. 'S.ERR' blinks surpassing

the permissible range. 'ERR' blinks when input scaling

setting is inappropriate.

Engineering unit indication: Sticker label attached

DC, AC, mV, V, kV, μA, mA, A, kA, mW, W,

kW, var, kvar, Mvar, VA, Hz, Ω, kΩ, MΩ,

cm, mm, m, m/sec, mm/min, cm/min, m/min,

N, kN, Pa, kPa, MPa, t, t/h, ℃, °F, %RH, J,

kJ, MJ, rpm, sec, min, pH, %, ppm, etc.

INPUT SPECIFICATIONS

■ AC Input voltage

Frequency: 40 - 100 Hz

Overload capacity: 120 % of max. measurement range

(continuous)

• V1 Max. input: 10 V

• V2 Max. input: 100 V

• V3, V4, V5 Max. input: 500 V

Input burden: ≤ 0.5 VA

■ Hold Input: Dry contact input

Detecting level: ≤ 1.5 V

Sensing: Approx. 5 V DC, 1 mA

INSTALLATION

Power consumption

•AC:

≤ 2.7 VA for 100 – 120 V

≤ 3.4 VA for 200 – 240 V

•DC: ≤ 1.0 W

Operating temperature: -10 to +55°C (14 to 131°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Mounting: Panel flush mounting

Weight: 180 g (0.40 lb)

PERFORMANCE

Input accuracy: ±0.3% rdg ±1digit,

< 35 % of full scale: ±0.3% FS ±1digit

Temp. coefficient: ±0.015 %/°C (±0.008 %/°F)

Line voltage effect: ±0.2 % over voltage range

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 2000 V AC @ 1 minute

(input to power to ground)

STANDARDS & APPROVALS

EU conformity:

EMC Directive

EMI EN 61000-6-4

EMS EN 61000-6-2

Low Voltage Directive

EN 61010-1

Measurement Category I (input)

Installation Category II (power)

Pollution degree 2

Input to power: Reinforced insulation (300 V)

RoHS Directive