MODEL: 47NLVT

47NLVT SPECIFICATIONS

ES-9562 Rev.5 Page 2/5

https://www.m-system.co.jp/

Over-range indication: ‘-19999’ or ‘19999’ blinking for

display values out of the display range.

‘S.ERR’ and ‘Min’ or ‘Max’ blinking when the input signal is

out of the usable range.

Alarm status indication

L indicator: Green turns on when the L alarm is tripped.

H indicator: Red turns on when the H alarm is tripped.

P indicator: Amber turns on when none of the other alarms

is tripped.

Only ‘P’ turns on when no-alarm is selected with

alarm setpoint.

Function indicators:

Zro, Spn, D/P, Tch, Fnc, Min, Max

Display mode status and operation status, amber ON or

blink

Engineering unit indication: Sticker label attached

DC, AC, mV, V, kV, μA, mA, A, kA, mW, W,

kW, var, kvar, Mvar, VA, Hz, Ω, kΩ, MΩ,

cm, mm, m, m/sec, mm/min, cm/min, m/min,

N, kN, Pa, kPa, MPa, t, t/h, ℃, °F, %RH, J,

kJ, MJ, rpm, sec, min, pH, %, ppm, etc.

INPUT SPECIFICATIONS

A: Conformance range 4.00 - 20.00 mA DC

(Usable Range: 2.40 - 21.60 mA DC)

D: Conformance range 0.00 - 20.00 mA DC

(Usable Range: -2.00 - +22.00 mA DC)

4: Conformance range 0.000 - 10.000 V DC

(Usable Range: -1.000 - +11.000 V DC)

5: Conformance range 0.000 - 5.000 V DC

(Usable Range: -0.500 - +5.500 V DC)

6: Conformance range 1.000 - 5.000 V DC

(Usable Range: 0.600 - 5.400 V DC)

4W: Conformance range -10.000 - +10.000 V DC

(Usable Range: -12.000 - +12.000 V DC)

5W: Conformance range -5.000 - +5.000 V DC

(Usable Range: -6.000 - +6.000 V DC)

OUTPUT SPECIFICATIONS

■ Alarm Output: Photo MOSFET Relay

Rating: 26.4 V DC @ 100 mA (resistive load)

ON resistance: ≤ 5 Ω

INSTALLATION

Power consumption

•DC: 0.7 W max.

Operating temperature: -10 to +55°C (14 to 131°F)

Operating humidity: 10 to 90 %RH (non-condensing)

Mounting: Screw mounting

Weight: 120 g (0.26 lb)

PERFORMANCE

Accuracy

Display: ±0.1 % ± 1 digit

Temp. coefficient: ±0.015 %/°C (±0.008 %/°F)

Response time: ≤ 0.5 sec.

(alarm output: 0 – 100 % at 90 % setpoint)

Line voltage effect: ±0.1 % over voltage range

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 1500 V AC @ 1 minute (input to alarm

output to power to ground)

STANDARDS & APPROVALS

EU conformity:

EMC Directive

EMI EN 61000-6-4

EMS EN 61000-6-2

RoHS Directive