MODEL: 60S

60S SPECIFICATIONS

ES-6612 Rev.3 Page 3/5

http://www.m-system.co.jp/

DESCRIPTIONS

■ RUN Contact Output (LED) Behaviors

• Input module

The LED for the Input Modules turns ON when the network is on-line.

When there is an abnormality in the network, the LED turns OFF.

The network is reconfigured after an abnormality.

• Output module

The LED for the Output Modules turns ON when the network is on-line and the module receives data from the corresponding

Input Module.

When there is an abnormality in the network or there is no data receiving, the LED turns OFF.

■ Station Number (Address)

A) 1 input module and X output modules:

Match the address for input and output modules.

B) Computer interface:

Set address numbers to correspond with the computer as output module.

■ Transmission Time

Integrate all the transmission time for each process input module in the system.

•Analog input 16 points: 24.0 msec.

An analog module does not transmit all its signals in serial but does 1 point per each cycle. For example, when 1 contact input

module (DLA1, 32 points) and 1 analog input module (16 points) are connected, 32 point contact signal and 1 point analog

signal are transmitted in turn. One cycle time is therefore calculated as:

32 points × 1.5 msec. + 24 msec. = 72 msec.

This method is beneficial for giving a priority to contact signals which vary rapidly.

■ Applicable models for use with 60S Input Module

• 60S-162 (Ao 16 points)

• DLA1-xM1 (Ao 32 points; only the top 16 out of 32 are used)