MODEL: F2SP

F2SP SPECIFICATIONS

ES-5434 Rev.6 Page 2/3

http://www.m-system.co.jp/

INPUT SPECIFICATIONS

Excitation: 12 V DC @30 mA; shortcircuit protection

Frequency range: 0 – 50 Hz through 10 kHz

• Dry Contact: Mechanical contact or open collector

Pulse width time requirement: 20 μsec. min. for ON and

OFF (2 msec. for ranges <100 Hz)

Sensing: Approx. 12V DC @3 mA

ON/OFF level: ≤200 Ω/0.6 V for ON, ≥100k Ω/6 V for OFF

• Voltage Pulse: Square or sine waveforms

Pulse width time requirement: 20 μsec. min. for high and

low levels

Voltage range: -30 – +30 V DC

Hi level: 2 – 30 V p-p

Lo level: ≤1 V

Input impedance: 10k Ω minimum

OUTPUT SPECIFICATIONS

■ DC Current: 0 – 20 mA DC

Minimum span: 1 mA

Offset: Max. 1.5 times span

Load resistance: Output drive 15 V max.

■ DC Voltage: 0 – 12 V DC

Minimum span: 5 mV

Offset: Max. 1.5 times span

Load resistance: Output drive 1 mA max.; at ≥ 0.5 V

INSTALLATION

Current consumption

•DC: Approx. 80 mA

Operating temperature: -5 to +55°C (23 to 131°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Mounting: DIN rail

Weight: 150 g (0.33 lb)

PERFORMANCE in percentage of span

Accuracy: ±0.1 % (output 10 – 100 %)

Temp. coefficient: ±0.015 %/°C (±0.008 %/°F)

Response time: (0 – 90%)

Approx. 1.8 sec. with 0 – 50 Hz

Approx. 0.8 sec. with 0 – 100 Hz

Approx. 0.5 sec. with 0 – 500 Hz

Approx. 0.5 sec. with 0 – 10 kHz

Ripple: 0.2 %p-p max. with input ≥ 10 %

Line voltage effect: ±0.1 % over voltage range

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 2000 V AC @1 minute (input to output

to power to ground)

STANDARDS & APPROVALS

EU conformity:

EMC Directive

EMI EN 61000-6-4

EMS EN 61000-6-2

RoHS Directive

EN 50581

Approval:

UL/C-UL general safety requirements

(UL 3111-1, CAN/CSA-C22.2 No.1010-1)