DLA1-2C1-R datasheet(2/33 Pages) MSYSTEM

2 / 33 page

MODEL: DLA1

DLA1 SPECIFICATIONS

ES-6510 Rev.9 Page 2/33

http://www.m-system.co.jp/

Isolation: I/O to transmission section to power

Station No. setting: 2 rotary switches; 00 – FF (256)

■ Controller & Transmission Sections

Power indicator: Red LED turns ON in normal conditions;

OFF when the voltage level becomes low.

RUN indicator: Red LED turns OFF in error.

■ I/O Section

Contact I/O indicator LED: Red LEDs turn on when the

respective I/O channels are ON.

Analog I/O CPU RUN indicator LED: Red LED turns ON when

the CPU function proves normal, OFF in error.

■ RUN Contact Output: Contact opens in error.

Rated load: 100 V AC or 30 V DC @ 1 A (resistive load)

Maximum switching voltage: 120 V AC or 30 V DC

Maximum switching power: 100 VA or 30 W

Minimum load: 5 V DC @ 10 mA

Error detection

•Communication: The receiver units detect loss of

communication and wire break.

•CPU: Watch-dog timer

•Power voltage: Detects when the voltage supply to the

CPU drops by 10 %.

MULTIPLEX COMMUNICATION

Communication: Half-duplex, synchronous

Transmission: Conform to RS-422, EIA

Transmission speed: 125 kbps

Protocol: SIN-NET (M-System's; data format conforms to

SDLC)

Error check: CRC

■ Twisted-pair Cable

Cable: CPEV-0.9 dia.

Connection: Euro Type connector terminal

(Applicable wire size: ≤ 1.25 mm2, stripped length 8 mm)

Transmission Distance: 1 kilometer max. with 16 units

connected; 3 kilometers max. between 2 stations each of

which consists of 3 units

Terminator: Incorporated (Remove the attached jumper pin

when the unit is not located at the end of transmission line.)

■ Fiber Optics Cable

Link: JIS F07 connector (Consult factory for details)

Transmission distance: 1 kilometer max. with PCF

Transmission loss: 7 dB max.

■ Twisted-pair – Fiber Optics: Converting signals between

two media and waveform shaping

INSTALLATION

Power consumption

•AC: Approx. 17.5 VA max.

•DC: Approx. 17 W max. (1.1 A with 24 V)

Grounding: Not required in normal environments; 100 Ω or

less grounding resistance in noisy environments

Operating temperature: -5 to + 50°C (23 to 122°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Atmosphere: No corrosive gas or heavy dust

Mounting: Surface; Rack Mounting Frame (model: BX-1DL)

available

Weight: 2 kg (4.4 lb)

PERFORMANCE

Permissible power failure duration: ≤ 20 ms

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 1500 V AC @ 1 minute

(I/O to transmission to power to ground)

DLA1-2C1-R 数据表(PDF) 2 Page - M-System Co.,Ltd.

DLA1-2C1-R 数据表(HTML) 2 Page - M-System Co.,Ltd.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33

数据表下载