ST8024

17/23

Figure 10: Application Diagram

(1) These capacitors must be of the low ESR-type and be placed near the IC (within 100 mm).

(3) Make short, straight connections between CGND, C5 and the ground connection to the capacitor.

(5) Mount one low ESR-type 100 nF capacitor close to C1 contact (less than 100 mm from it).

(6) The connection to C3 should be routed as far from C2, C7, C4 and C8 and, if possible, surrounded by grounded tracks.

(7) Optional resistor bridge for changing the threshold of VDD . If this bridge is not required pin 18 should be connected to ground.