MODEL: JC-HL

JC-HL SPECIFICATIONS

ES-9041 Rev.3 Page 1/11

https://www.m-system.co.jp/

Remote I/O JC Series

HUB MODULE

53

(2.09)

mm (inch)

73

(2.87)

115

(4.52)

MODEL: JC–HL-[1]-1[2]-[3][4]

ORDERING INFORMATION

• Code number: JC-HL-[1]-1[2]-[3][4]

Specify a code from below for each of [1] through [4].

(e.g. JC-HL-7-12-R/H/Q)

• Specify the specification for option code /Q

(e.g. /SET)

[1] I/O TYPE

3: 3 port (trunk 1 port, feeder 2 port)

7: 7 port (trunk 1 port, feeder 6 port)

TERMINAL BLOCK

1: Tension clamp terminal block for power supply

RJ-45 Modular jack for communication

[2] COMMUNICATION CONNECTOR PIN ASSIGNMENT

1: 3, 4 - 5, 6 pair wiring

(M-System HLS related products standard pin assignment)

2: 4, 5 - 3, 6 pair wiring

(Ethernet LAN cable pin assignment)

[3] POWER INPUT

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

R5: 16 - 32 V DC

(Operational voltage range 15 - 33 V DC, ripple 10 %p-p max.)

[4] OPTIONS (multiple selections)

Communication Mode

blank: Full-duplex

/H: Half-duplex

Other Options

blank: none

/Q: Option other than the above (specify the specification)

SPECIFICATIONS OF OPTION: Q

EX-FACTORY SETTING

/SET: Preset according to the Ordering Information Sheet

(No. ESU-9041)

FUNCTIONS & FEATURES

The HUB Module for HLS (model: JC-HL) extends total length

of network cable and branch cable of HLS (Hi-speed Link

System). Total max. length is 2.4 km when transfer rate is 3

Mbps. In order to connect the JC-HL, the master unit

configuring HLS must support HUB module.

HLS is the abbreviation for “Hi-speed Link System” of Step

Technica Co., Ltd.

RELATED PRODUCTS

• High-speed link system I/O modules (model: R7F4DH,

R7K4DH, R7HL, R7FN etc.)

• MP2200/MP2300 series use HLS master module (model:

MPHLS)

GENERAL SPECIFICATIONS

Number of port:

JC-HL-3: Trunk 1 port, feeder 2 port

JC-HL-7: Trunk 1 port, feeder 6 port

Max. number of inserted HUBs: 7

(Depending on specification of master unit)

Connectable devices: The products conforming to HLS

Connection

Network: RJ-45 Modular Jack

Power input: Separable tension clamp terminal

Power on LED: PWR (green) turns on while the power is

supplied.

HLS COMMUNICATION

Communication mode: Full-duplex or half-duplex

Network cable

• Shield cable

ZHY262PS (Shinko Seisen Industry Co., Ltd.)

ZHT262PS (Shinko Seisen Industry Co., Ltd.)

• Dual-shield cable

ZHY262PBA (Shinko Seisen Industry Co., Ltd.)