MODEL: JC-HL

JC-HL SPECIFICATIONS

ES-9041 Rev.3 Page 2/11

https://www.m-system.co.jp/

Transmission distance / Transfer rate:

Refer to the table below (Selectable with

DIP switch. Factory default: 12 Mbps)

Terminating resistor:

Trunk built-in (Selectable with DIP switch. Factory default:

disable)

Feeder built-in

Status indicator LEDs: ERR, LNK

(Refer to the instruction manual for details)

Number of inserted HUBs

Transfer rate

0

1

2

3

4

5

6

7

12Mbps

100m 200m 300m 400m 500m 600m 700m 800m

6Mbps

200m 400m 800m

1km

1.2km 1.4km 1.6km 1.8km

3Mbps

300m 600m 900m 1.2km 1.5km 1.8km 2.1km 2.4km

INSTALLATION

Rated current for power supply connector: 8A

Power consumtpion:

JC-HL-3: Approx. 1 W

JC-HL-7: Approx. 1.4 W

Operating temperature: -10 to +55°C

Operating humidity: 10 to 90 %RH (non-condensing)

Atmosphere: No corrosive gas or heavy dust

Mounting: Surface or DIN rail

Weight

JC-HL-3: 150 g (0.33 lb)

JC-HL-7: 160 g (0.35 lb)

PERFORMANCE

Insulation resistance: ≥ 100 MΩ with 500 V DC

JC-HL-3 (HLS0A or HLS0B to HLS1 or HLS2 or FE to power)

JC-HL-7 (HLS0A or HLS0B to HLS1 or HLS2 or HLS3 or HLS4

or HLS5 or HLS6 or FE to power)

Dielectric strength: 1500 V AC @ 1 minute

JC-HL-3 (HLS0A or HLS0B to HLS1 or HLS2 or FE to power)

JC-HL-7 (HLS0A or HLS0B to HLS1 or HLS2 or HLS3 or HLS4

or HLS5 or HLS6 or FE to power)

STANDARDS & APPROVALS

Refer to the manuals to comply with the standards.

EU conformity:

EMC Directive

EMI EN 61000-6-4

EMS EN 61000-6-2

RoHS Directive

MOUNTING REQUIREMENTS unit: mm (inch)