L6986I datasheet(38/60 Pages) STMICROELECTRONICS

38 / 60 page

Figure 43. Primary (blue) winding current, secondary (pink) winding current and magnetizing current

(black)

ILsec

ILpri

ILpri_pos_peak

ILsec_peak

ILpri_neg_peak

Therefore, setting the current ripple ΔIL, the inductance is so defined:

Lpri = VIN−VOUT_pri∙VOUT_pri

VIN∙fSW∙∆IL

(39)

As example, assuming IOUT_prim = 500 mA, IOUT_sec = 100 mA, N= 5, the current ripple can be set around 30% of

the total current IOUT_pri + N×IOUT_sec = 1 A, therefore 300 mA. If VIN = 12 V, VOUT_pri = 5 V and fSW = 500 kHz,

the inductor value should be 19.4 µH (→ 18 µH or 22 µH the closest standardized value).

Peak and RMS current

As any inductor, peak and RMS current for each winding must be calculated in order to define saturation and

RMS currents that the transformer should fulfill.

For the primary winding, the equations below are valid:

Ipri_pos_peak = IOUT_pri+IOUT_secN+ΔIpri2

(40)

Ipri_RMS = IOUT_pri+IOUT_secN∙ 1+112∙ ΔIpri∙N

N∙IOUT_pri+IOUT_sec

(41)

For the secondary winding the peak current can change depending on the leakage inductance. In the picture

below secondary winding current waveforms with different leakage inductances are simulated. It is evident

how the peak current can significantly vary. Considering the target leakage inductance value for an iso-buck

(recommended up to 1% of the primary inductance), the waveform can be approximated with a sawtooth shape

and the peak and RMS currents can be hence estimated as:

Isec_pos_peak = 2∙IOUT_sec

1−D

(42)

Isec_RMS = Isec_pos_peak∙ 1−D3

(43)

The equation (44) emphasizes what mentioned about the recommended duty cycle.

A duty cycle higher than 50-60% significantly increases the peak current in the secondary winding (see figure

below). Furthermore, this affects the negative peak current at the primary side (see Figure 44).

L6986I

Design of the external components

DS13647 - Rev 1

page 38/60

L6986I 数据表(PDF) 38 Page - STMicroelectronics

L6986I 数据表(HTML) 38 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

数据表下载