MODEL: MATP

MATP SPECIFICATIONS

ES-8150 Rev.4 Page 1/3

http://www.m-system.co.jp/

Lightning Surge Protectors for

Electronics Equipment M-RESTER

SURGE PROTECTOR FOR PHOTOVOLTAIC SYSTEM

Functions & Features

• Surge protection for photovoltaic array and power

conditioner.

•High discharge current capacity 20 kA or 40 kA (8/20 μs)

• Degraded head element is automatically separated from

the power lines by the incorporated thermal breaker, and

the LED lamp (turns off) and the relay contact alerts the

failure status.

• Breakdown of the surge protector remotely detected with

the alarm output

MODEL: MATP–600[1][2]

ORDERING INFORMATION

• Code number: MATP-600[1][2]

Specify a code from below for each [1] and [2].

(e.g.MATP-600MA)

OPERATIONAL VOLTAGE

600: 600 V DC

[1] MAXIMUM DISCHARGE CURRENT

M: 20kA (8/20 μsec.)

H: 40kA (8/20 μsec.)

[2] ALARM OUTPUT

A: With

Y: Without

GENERAL SPECIFICATIONS

Construction: Standalone; terminal access at the front

Degree of protection: IP20 (If the solderless terminals are

covered with insulation tubes.)

Surge protection type: Voltage limiting type one-port SPD

Connection

Line: M5 screw terminal (torque: 2.5 N·m)

Alarm output: Tension clamp

Applicable wire size

Line: See the drawing below.

Screw terminal

Line: Nickel-plated steel

Alarm output: Tin-plated copper alloy

Housing material: Flame-resistant resin (black)

Alarm output: Trips when the thermal breaker operates.

(N.C. contact)

Rated load:

250 V AC @50 mA (resistive load)

24 V DC @50 mA (resistive load)

Safety function: Thermal breaker incorporated

Monitor LED: Green LED turns on during normal conditions

between 150 and 600 V DC, and turns off during failure

condition, power off and the thermal breaker operating.

F

d : M5 use

B ≤ 13.0 mm

F ≥ 7.0 mm

(F ≥ 8.2 mm for sharing terminals)

T ≤ 1.8 mm

• Applicable Solderless Terminal Size

diameter d

INSTALLATION

Operating temperature: -25 to +80°C (-13 to +176°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Mounting: DIN Rail

Weight

MATP-600Mx: 200 g (0.44 lb)

MATP-600Hx: 250 g (0.55 lb)

PERFORMANCE

Max. continuous operating voltage (Uc): 600 V DC

Discharge voltage: (Line to earth) 600 V DC

Maximum surge voltage: 2.5 kV

Maximum (Imax) and Nominal (In) discharge current: (8/ 20

μs)

• MATP-600Mx: 20 kA (Imax), 10 kA (In)

• MATP-600Hx: 40 kA (Imax), 20 kA (In)

Response time: ≤ 4 nsec

Leakage current: ≤ 1 mA

Insulation resistance: ≥ 100 MΩ with 500 V DC (line to

alarm output)

Dielectric strength: 2000 V AC @ 1 minute (line to alarm

output)

Surge protection: IEC 61643-1 Class II