Germany: +49 621 776 1111

Pepperl+Fuchs Group

Refer to "General Notes Relating to Pepperl+Fuchs Product Information".

USA: +1 330 486 0001

Singapore: +65 6779 9091

www.pepperl-fuchs.com

fa-info@us.pepperl-fuchs.com

fa-info@sg.pepperl-fuchs.com

fa-info@de.pepperl-fuchs.com

Laser thru-beam sensor

OBE10M-R2-SE2-L

4

1. Make sure that there are no objects in the beam path and that the sensor is connected to the power supply.

2. Connect the white cable on the receiver (WH/IN) to the blue cable (BU/0 V) on the receiver.

The green and yellow LED indicators flash simultaneously at 2.5 Hz

3. Position the object in the beam path.

4. Disconnect the white cable on the receiver (WH/IN) from the blue cable (BU/0 V) on the receiver.

The green and yellow LED indicators flash alternately at 2.5 Hz

5. The end of the Teach-in process is indicated when the green LED indicator lights up static.

Maximum Teach-In

When using this Teach-in method, the following settings are made on the thru-beam sensor:

• The gain is set to a maximum

• The signal threshold is set to a minimum

Recommended application:

Enables an object to be detected with a high excess gain. This can be useful if there is severe environmental contamination or to achieve long

operating times.

Make sure that there are no objects in the beam path and that the sensor is connected to the power supply.

6. Cover the receiver or transmitter.

7. Connect the white cable on the receiver (WH/IN) to the blue cable (BU/0 V) on the receiver.

The green and yellow LED indicators flash simultaneously at 2.5 Hz

8. Disconnect the white cable on the receiver (WH/IN) from the blue cable (BU/0 V) on the receiver.

The green and yellow LED indicators flash alternately at 2.5 Hz

9. The end of the Teach-in process is indicated when the green LED indicator lights up static.

• The irradiation can lead to irritation especially in a dark environment. Do not point at people!

• Maintenance and repairs should only be carried out by authorized service personnel!

• Attach the device so that the warning is clearly visible and readable.

• The warning accompanies the device and should be attached in immediate proximity to the device.

• Caution – Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation

exposure.

Laser notice laser class 1

Signal strength

Threshold level

Teach-in value 1 (avg)

Contrast levels

Teach-in value 2 (avg)

t

Max.

0

t

Signal strength

Threshold level

t

Max.

0