HPR

www.vishay.com

Vishay Draloric

Revision: 01-Feb-18

3

Document Number: 21050

THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT

DESCRIPTION

Stainless steel caps (terminations) are firmly pressed onto a

high grade alumina ceramic core. The resistor element is a

resistive wire, which is wound on this ceramic core. Resistor

is coated with silicone cement protective coating designed

for electrical, mechanical and climatic protection.

MATERIALS

Vishay acknowledges the following systems for the

regulation of hazardous substances:

• IEC 62474, Material Declaration for Products of and for the

Electrotechnical Industry, with the list of declarable

• The

Global

Automotive

Declarable

Substance

List

• The REACH regulation (1907/2006/EC) and the related list

supply chain

The products do not contain any of the banned substances

as per IEC 62474, GADSL, or the SVHC list, see

Hence the products fully comply with the following

directives:

• 2000/53/EC End-of-Life Vehicle Directive (ELV) and

Annex II (ELV II)

• 2011/65/EU

Restriction

of

the

Use

of

Hazardous

Substances

Directive

(RoHS)

with

amendment

2015/863/EU

• 2012/19/EU Waste Electrical and Electronic Equipment

Directive (WEEE)

Vishay pursues the elimination of conflict minerals from its

supply

chain,

see

the

Conflict

Minerals

Policy

at

ASSEMBLY

The resistor is mounted inside noise suppressor spark plug

cap. Connections are taken mechanically through a spring

and through a screw electrode. The spark plug cap

assembly is molded with epoxy resin or thermoplastic

materials.

Notes



www.gadsl.org

TEST PROCEDURES AND REQUIREMENTS

IEC 60115-1

CLAUSE

IEC 60068-2

TEST

METHOD

TEST

PROCEDURE

REQUIREMENTS PERMISSIBLE

CHANGE (

R)

4.13

-

Short time overload

Room temperature;

10 cycles; 5 s ON and 45 s OFF

± 2 %

4.19

14 (Na)

Rapid change of

temperature

30 min at -55 °C and

30 min at +155 °C;

500 cycles

± 3 %

4.23

-

Climatic sequence:

-

± 2 %

4.23.2

2 (Bb)

dry heat

16 h; 200 °C

4.23.3

30 (Db)

damp heat

(accelerated)

24 h; 55 °C;

90 % to 100 % RH

4.23.4

1 (Ab)

cold

2 h; -40 °C

4.23.5

13 (M)

low air pressure

2 h; 8.5 kPa; 15 °C to 35 °C

4.23.6

30 (Db)

damp heat remaining

cyclic

5 days; 55 °C;

95 % to 100 % RH; 5 cycles

4.24

78 (Cab)

Damp heat

(steady state)

56 days; (40 ± 2) °C;

(93 ± 5) % RH

± 3 %

4.25.1

-

Endurance

(at room temperature)

1000 h;

1.5 h ON and 0.5 h OFF

± 3 %

4.25.3

-

Endurance

(at 200 °C)

1000 h;

without load

± 5 %