INA333 datasheet(30/47 Pages) TI

30 / 47 page

10 Power Supply Recommendations

The nominal performance of the INA597 is specified with a supply voltage of ±15 V and midsupply reference

voltage. The device operates using power supplies from ±2.25 V (4.5 V) to ±18 V (36 V) and non-midsupply

reference voltages with excellent performance. Parameters that can vary significantly with operating voltage and

reference voltage are shown in Section 7.7.

11 Layout

11.1 Layout Guidelines

Attention to good layout practices is always recommended. For best operational performance of the device, use

good PCB layout practices, including:

• Take care to make sure that both input paths are well-matched for source impedance and capacitance to

avoid converting common-mode signals into differential signals.

• Noise propagates into analog circuitry through the power pins of the circuit as a whole and of the device.

Bypass capacitors reduce the coupled noise by providing low-impedance power sources local to the analog

circuitry.

– Connect low-ESR, 0.1-μF ceramic bypass capacitors between each supply pin and ground, placed as

close to the device as possible. A single bypass capacitor from V+ to ground is applicable for single-

supply applications.

• To reduce parasitic coupling, run the input traces as far away from the supply or output traces as possible.

If these traces cannot be kept separate, crossing the sensitive trace perpendicular is much better than in

parallel with the noisy trace.

• Place the external components as close to the device as possible.

• Keep the traces as short as possible.

INA597

SBOS385B – AUGUST 2019 – REVISED APRIL 2021

www.ti.com

Submit Document Feedback

Product Folder Links: INA597

INA333 数据表(PDF) 30 Page - Texas Instruments