MODEL: R1D-GH2

R1D-GH2 SPECIFICATIONS

ES-5958 Rev.8 Page 1/5

http://www.m-system.co.jp/

Remote I/O R1X Series

THERMOCOUPLE & DC INPUT MODULE

(16 points; DeviceNet)

Functions & Features

• 16-point thermocouple or DC inputs

• DeviceNet interface

40

(1.57)

115

(4.53)

mm (inch)

175 (6.89)

MODEL: R1D-GH2T-[1][2]

ORDERING INFORMATION

• Code number: R1D-GH2T-[1][2]

Specify a code from below for each [1] and [2].

(e.g. R1D-GH2T-M2/Q)

• Specify the specification for option code /Q

(e.g. /C01)

• Use Ordering Information Sheet (No. ESU-5956). Default

setting will be used if not otherwise specified.

Factory default setting

Input type: DC Voltage ±5 V

Burnout protection: No burnout

Cold junction compensation: No

FIELD TERMINAL TYPE

T: M3 screw terminals

[1] POWER INPUT

AC Power

M2: 100 – 240 V AC (Operational voltage range 85 – 264 V,

47 – 66 Hz)

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

[2] OPTIONS

blank: none

/Q: With options (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

RELATED PRODUCTS

• Resistor module (model: REM3-250)

• R1X configurator software (model: R1CON)

• EDS file

The EDS file and configurator software are downloadable at

M-System’s web site.

A dedicated cable is required to connect the module to the

PC. Please refer to the internet software download site or

the users manual for the PC configurator for applicable

cable types.

GENERAL SPECIFICATIONS

Connection

Power input, DeviceNet: Euro type connector terminal

stripped length 7 mm)

Input: M3 screw terminals (torque 0.6 N·m)

Configurator: 2.5 dia. miniature jack; RS-232-C level

Screw terminal: Nickel-plated steel

Housing material: Flame-resistant resin (gray)

Isolation: Input to DeviceNet to power

Power indicator: Green LED turns on with power supplied.

DeviceNet COMMUNICATION

Transmission cable: Approved for DeviceNet

Node address setting: Rotary switch or software; 00 – 63

Baud rate setting: DIP switch or software

MS (Module Status) indicator: Bi-color (green/red)

LED indicates device status.

NS (Network Status) indicator: Bi-color (green/red)

LED indicates status of the communication link.

Device Profile: Generic Device

INPUT SPECIFICATIONS

■ Thermocouple or DC input, 16 points

(Common negative for DC input)

•Measuring range ±20 V, ±5 V, ±1 V: Atten. SW ON (3)

•Measuring range ±0.8 V, ±0.2 V, ±50 mV, ±10m V: Atten.

SW OFF (1)

Input resistance: 300 kΩ

Thermocouple types: PR, K, E, J, T, B, R, S, C, N, U, L, P

Sampling rate: 150 millisec./16 points

■ A/D conversion output: 16-bit signed binary (negative

range represented by 2’s complements)