MODEL: R3-DC64C

R3-DC64C SPECIFICATIONS

ES-8349 Rev.5 Page 1/6

https://www.m-system.co.jp/

Remote I/O R3 Series

DISCRETE OUTPUT MODULE

(PNP transistor output, 64 points, shortcircuit protection)

27.5 [1.08]

130

[5.12]

109

[4.29]

mm [inch]

MODEL: R3–DC64C[1][2]

ORDERING INFORMATION

• Code number: R3-DC64C[1][2]

Specify a code from below for each of [1] and [2].

(e.g. R3-DC64CW/CE/Q)

• Specify the specification for option code /Q

(e.g. /C01)

NO. OF CHANNELS

64: 64

OUTPUT

C: PNP transistor

[1] COMMUNICATION MODE

S: Single

W: Dual

[2] OPTIONS (multiple selections)

Standards & Approvals

blank: Without CE

/CE: CE marking

Other Options

blank: none

/Q: Option other than the above (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

RELATED PRODUCTS

• Connector terminal block (model: CNT)

• Special cable with 40-pin connector (model: FCN)

GENERAL SPECIFICATIONS

Connection

Internal bus: Via the Installation Base (model: R3-BSx)

Output: 40-pin connector (Fujitsu FCN-365P040-AU)

Internal power: Via the Installation Base (model: R3-BSx)

Isolation: Do11 thru Do18 to Do21 thru Do28 to Do31 thru

Do38 to Do41 thru Do48 to Do51 thru Do58 to Do61 thru

Do68 to Do71 thru Do78 to Do81 thru Do88 to internal bus

or internal power

Output hold setting: Setting for communication error with

side DIP SW

RUN indicator: Bi-color (red/green) LED;

Red when the bus A operates normally;

Green when the bus B operates normally;

Amber when both buses operate normally.

ERR indicator: Green LED turns on in normal operating

conditions.

Output status indicator: Red LED; turns on with the output

ON.

Group selector: Switches the output status indicator

CN1:

A. 1 - 8: Do11 - Do18, 9 - 16: Do21 - Do28

B. 1 - 8: Do31 - Do38, 9 - 16: Do41 - Do48

CN2:

A. 1 - 8: Do51 - Do58, 9 - 16: Do61 - Do68

B. 1 - 8: Do71 - Do78, 9 - 16: Do81 - Do88

OUTPUT SPECIFICATIONS

Output: Open collector, 64 points

Isolation: Optical isolator

Rated load voltage

Nominal: 19.2 to 30 V DC

Absolute: 45 V DC

Rated load current: 0.25 A per point, 1.0 A per common

Voltage drop at ON: ≤ 2.0 V

Leakage current at OFF: ≤ 0.3 mA

(24 V DC load, all points OFF)

ON delay: ≤ 1.0 msec.

OFF delay: ≤ 3.5 msec.

Shortcircuit protection: Works for 0.7 A or more;

automatically resets after recovery

(When driving an inductive load, connect a diode in parallel

with the load.)