MODEL: R3-NF1

R3-NF1 SPECIFICATIONS

ES-8429 Rev.10 Page 1/7

http://www.m-system.co.jp/

Remote I/O R3 Series

T-Link INTERFACE MODULE

(Fuji Electric T-Link use)

119

(4.69)

27.5 (1.08)

130

(5.12)

mm (inch)

MODEL: R3–NF1–[1][2]

ORDERING INFORMATION

• Code number: R3-NF1-[1][2]

Specify a code from below for each of [1] and [2].

(e.g. R3-NF1-R/Q)

• Specify the specification for option code /Q

(e.g. /C01/SET)

[1] POWER INPUT

N: No power supply

AC Power

K3: 100 – 120 V AC

(Operational voltage range 85 - 132 V, 47 - 66 Hz) *

L3: 200 – 240 V AC

(Operational voltage range 170 - 264 V, 47 - 66 Hz) *

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.) *

* Not selectable for use with independent power modules or

network modules with the internal power input options.

[2] OPTIONS

blank: none

/Q: With options (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

EX-FACTORY SETTING

/SET: Preset according to the Ordering Information Sheet

(No. ESU-8429)

GENERAL SPECIFICATIONS

Connection

T-Link: Euro type connector terminal (applicable wire size:

Internal bus: Via the Installation Base

(model: R3-BSx)

Internal power: Via the Installation Base (model: R3-BSx)

Power input, RUN contact output: M3 separable screw

terminal (torque 0.5 N·m)

Screw terminal: Nickel-plated steel

Isolation: T-Link to internal bus or internal power to power

input to RUN contact output to FG

Input error data setting: Input value setting at input module

error with side DIP SW

Dual communication setting: Set with the side DIP switch

Data allocation setting: Set with the side DIP switch

Status data setting: WITHOUT / WITH (side DIP SW)

(Not available with firmware version earlier than 1.02)

I/O points setting: 4, 8, 16, 64 (front DIP SW)

I/O type setting: Input only, output only, input/output mixed

(front DIP SW)

RUN indicator: Bi-color (green/red) LED; Green ON in normal

communication; Red ON when receiving data (Function

selected with DIP SW)

ERR indicator: Bi-color (green/red) LED;

Green ON or blinking at communication error (Blinking with

setting errors); Red ON at transmitting data (Function

selected with DIP SW)

■ RUN CONTACT OUTPUT

RUN contact: Turns ON while the green RUN LED is ON (T-

Link in normal communication).

Rated load: 250 V AC @ 0.5 A (cos ø = 1)

30 V DC @ 0.5 A (resistive load)

Maximum switching voltage: 250 V AC or 30 V DC

Maximum switching power: 250 VA or 150 W

Minimum load: 1 V DC @ 1 mA

driving an inductive load, external contact protection and

noise quenching recommended.

T-Link SPECIFICATIONS

Node address: Rotary switch; 00 – 99

Configuration: Multi-drop

Communication: Half-duplex

Baud rate: 500 kbps

Transmission media/distance: