MODEL: R7FN-SVF4

R7FN-SVF4 SPECIFICATIONS

ES-7808-AB Rev.0 Page 1/6

http://www.m-system.co.jp/

Remote I/O R7 Series

FLEX NETWORK I/O MODULE

(High-speed DC voltage/current input, 4 points, non-

isolated)

Functions & Features

• 4 points high-speed DC voltage/current input module for

FLEX NETWORK

• Input range can be selected with the front DIP switches for

all channels.

• Easy parameter setting of individual channels with M-

System's configurator software

FLEX NETWORK is registered trademark of Digital

Electronics Corporation in Japan.

115 (4.53)

53 (2.09)

54 (2.13)

mm (inch)

MODEL: R7FN–SVF4-R[1]

ORDERING INFORMATION

• Code number: R7FN-SVF4-R[1]

Specify a code from below for [1].

(e.g. R7FN-SVF4-R/Q)

• Specify the specification for option code /Q

(e.g. /C01/SET)

I/O TYPE

SVF4: DC voltage /current input high-speed, 4 points

(non-isolated) (10 V/20 mA)

POWER INPUT

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

[1] OPTIONS

blank: none

/Q: Options other than the above (specify the specification)

SPECIFICATIONS OF OPTION: Q (multiple selections)

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

EX-FACTORY SETTING

/SET: Preset according to the Ordering Information Sheet

(No. ESU-7808-SVF4)

RELATED PRODUCTS

• PC configurator software (model: R7CON)

The configurator software is downloadable at M-System’s

web site.

A dedicated cable is required to connect the module to the

PC. Please refer to the internet software download site or

the users manual for the PC configurator for applicable

cable types.

• Screen editor software (model: GP-Pro EX)

Screen editor software GP-Pro EX (Ver.2.70 or higher) is

available.

For versions between 2.60 and 2.70, the driver must be

installed. The driver is downloadable at Digital Electronics

Corporation's web site. http://www.proface.co.jp/

GENERAL SPECIFICATIONS

Connection: M3 separable screw terminal (torque 0.5 N·m)

Solderless terminal: Refer to the drawing at the end of the

section.

• Communication cable

Recommended manufacture: Japan Solderless Terminal

MFG.Co.Ltd

• Others

Recommended manufacture: Japan solderless terminal

MFG.Co.Ltd, Nichifu Co.,ltd

Screw terminal: Nickel-plated steel

Housing material: Flame-resistant resin (gray)

Isolation: Input to FLEX NETWORK to power to FG

Zero adjustments: Configurable via R7CON

Span adjustments: Configurable via R7CON

Input range: Selectable with the DIP SW on the front of the

unit or configurable via R7CON

Conversion rate: Configurable via R7CON

Number of times of averaging: No averaging (*), 2 samples,

4 sampes, 8 samples

Configurable via R7CON

(*) Factory default setting

Status indicator LED: PWR, RUN

(Refer to the instruction manual)