MODEL: R7FN-YV2

R7FN-YV2 SPECIFICATIONS

ES-7808-D Rev.0 Page 1/6

http://www.m-system.co.jp/

Remote I/O R7 Series

FLEX NETWORK I/O MODULE

(2 points DC voltage output, isolated)

Functions & Features

• 2 points DC voltage output module for FLEX NETWORK

• Output range can be selected with the front DIP switches

for all channels.

• Easy parameter setting of individual channels with M-

System's configurator software

FLEX NETWORK is registered trademark of Digital

Electronics Corporation in Japan.

115 (4.53)

53 (2.09)

54 (2.13)

mm (inch)

MODEL: R7FN–YV2-R[1]

ORDERING INFORMATION

• Code number: R7FN-YV2-R[1]

Specify a code from below for [1].

(e.g. R7FN-YV2-R/Q)

• Specify the specification for option code /Q

(e.g. /C01/SET)

I/O TYPE

YV2: DC voltage output, 2 points

POWER INPUT

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

[1] OPTIONS

blank: none

/Q: Options other than the above (specify the specification)

SPECIFICATIONS OF OPTION: Q (multiple selections)

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

EX-FACTORY SETTING

/SET: Preset according to the Ordering Information Sheet

(No. ESU-7808-YV2)

RELATED PRODUCTS

• PC configurator software (model: R7CON)

The configurator software is downloadable at M-System’s

web site.

A dedicated cable is required to connect the module to the

PC. Please refer to the internet software download site or

the users manual for the PC configurator for applicable

cable types.

• Screen editor software (model: GP-Pro EX)

Screen editor software GP-Pro EX (Ver.2.70 or higher) is

available.

For versions between 2.60 and 2.70, the driver must be

installed. The driver is downloadable at Digital Electronics

Corporation's web site. http://www.proface.co.jp/

GENERAL SPECIFICATIONS

Connection: M3 separable screw terminal (torque 0.5 N·m)

Solderless terminal: Refer to the drawing at the end of the

section.

• Communication cable

Recommended manufacture: Japan Solderless Terminal

MFG.Co.Ltd

• Others

Recommended manufacture: Japan solderless terminal

MFG.Co.Ltd, Nichifu Co.,ltd

Screw terminal: Nickel-plated steel

Housing material: Flame-resistant resin (gray)

Isolation: Output 0 to output 1 to FLEX NETWORK to power

to FG

Zero adjustments: Configurable via R7CON

Span adjustments: Configurable via R7CON

Output range: Selectable with the front DIP SW or

configurable via R7CON

Output at the loss of communication:

Output hold (*), Output clear

Selectable with the front DIP SW

(*) factory default setting

Status indicator LED: PWR, RUN

(Refer to the instruction manual)

■Recommended solderless terminal

3.3 (.13) max

mm (inch)