STUSB02E

1 Pin Configuration

3/20

1

Pin Configuration

Table 1.

Pin Description

Figure 1.

Pin Connections (Top View )

PlN N°

SYMBOL

I/O

NAME AND FUNCTION

0

N.C.

Not Connected.

15

I

System Interface Supply Voltage (1.6V to 3.6V). (return) Provides reference

supply voltage for system I/O interface signals.

1

SPD

I

Edge Rate Control. A logic HIGH operates at edge rates for “fullspeed”

operation. A logic LOW operates edge rates for “lowspeed” operation.

2

RCV

O

Receive Data. Output for USB differential data. (see Table 2)

3

VP

I/O

If OE# = H, VP = Receiver output (+)

If OE# = L, VP = Driver input (+) (see Table 2)

4

VM

I/O

If OE# = H, VM = Receiver output (-)

If OE# = L, VM = Driver input (-) (see Table 2)

5CON

I

6

GND

Ground Reference

7

SUS

I

Suspend (active-high). Turns off internal circuits to reduce supply current.

9OE#

I

Output Enable (active-low). Enables transceiver data transmission onto the bus.

When not active, the transceiver is in the receive mode. (see Table 2)

10, 11

D-, D+

I/O

Differential data lines that conform to the USB v2.0 standard. (see Table 2)

12

VTRM

O

3.3V Reference Supply Output. Requires a 1.0µF decoupling capacitor for

stability.

13

O

Pull-up Supply Voltage Output. Used to connect 1.5K pull-up speed detect

14

I

USB Bus Supply Voltage (4V to 5.5V). Supplies power to the USB transceiver

and internal circuitry.

8

N.C.

Not connected.

16

O