Germany: +49 621 776 4411

Pepperl+Fuchs Group

Refer to “General Notes Relating to Pepperl+Fuchs Product Information”.

USA: +1 330 486 0001

Singapore: +65 6779 9091

www.pepperl-fuchs.com

fa-info@us.pepperl-fuchs.com

fa-info@sg.pepperl-fuchs.com

fa-info@de.pepperl-fuchs.com

Distance sensor

OMT100-R103-2EP-IO

3

Teach-In:

You can use the rotary switch to select the relevant switching threshold A and/or B for teaching in for switch signal Q1 or Q2.

The yellow LEDs indicate the current state of the selected output.

To store a threshold value, press and hold the "TI" button until the yellow and green LEDs flash in phase (approx. 1 s). Teach-In starts when the

"TI" button is released.

Successful Teach-In is indicated by alternating flashing (2.5 Hz) of the yellow and green LEDs.

An unsuccessful Teach-In is indicated by rapidly alternating flashing (8 Hz) of the yellow and green LEDs.

After an unsuccessful Teach-In, the sensor continues to operate with the previous valid setting after the relevant visual fault signal is issued.

Different switching modes can be defined by teaching in the relevant distance measured values

for the switching thresholds A and B:

Single point mode:

Window mode:

Every taught-in switching threshold can be retaught (overwritten) by pressing the „TI“ button

again.

Pressing and holding the "TI" button for > 4 s completely deletes the taught-in value. The yellow and green LEDs go out simultaneously to

indicate that this procedure has been completed. Successful resetting is indicated by alternating flashing (2.5 Hz) of the yellow and green LEDs.

Resetting to Factory Default Settings

Press the „TI“ button for > 10 s in rotary switch position ‚O' to reset to factory default settings. The yellow and green LEDs go out simultaneously

to indicate the resetting.

Resetting process starts when the "TI" button is released and is indicated by the yellow LED. After the process the sensor works with factory

default settings, immediately.

OMT:

• Factory default settings switch signal Q1:

Switch signal active, window mode

• Factory default settings switch signal Q2:

Switch signal active, window mode

OQT:

• Factory default settings switch signal Q1:

Switch signal active, BGS mode (background suppression)

• Factory default settings switch signal Q2:

Switch signal active, BGS mode (background suppression)

Setting different operating modes via the IO-Link interface

The devices are equipped with an IO-Link interface as standard for diagnostics and parameterization tasks to ensure optimum

adjustment of the sensors to the relevant application.

Single point mode operating mode (one switch point):

• "Detection of objects irrespective of type and color in a defined detection range. Objects in the background are suppressed.

• "The switch point corresponds exactly to the set point.

Window mode operating mode (two switch points):

• Detection of objects irrespective of type and color in a defined detection range. Reliable detection when object leaves the detection range.

• Window mode with two switch points.

Cable length

2 m

Approvals and certificates

UL approval

E87056 , cULus Listed , class 2 power supply , type rating 1

Preferences

B

A leer

A

B leer

BA

A > B

AB

B > A

Configuration via IO-Link interface

active detection range

Background

suppression

active detection range

Background suppression

Foreground suppression