AT45DB021E datasheet(21/74 Pages) DIALOG

21 / 74 page

AT45DB021E

DS-AT45DB021E—8789J—03/2021

Sector Protection

Two protection methods, hardware and software controlled, are provided for protection against inadvertent or

erroneous program and erase cycles. The software controlled method relies on the use of software commands to

enable and disable sector protection while the hardware controlled method employs the use of the Write Protect

(WP) pin. The selection of which sectors that are to be protected or unprotected against program and erase

operations is specified in the nonvolatile Sector Protection Register. The status of whether or not sector protection

has been enabled or disabled by either the software or the hardware controlled methods can be determined by

checking the Status Register.

8.1

Software Sector Protection

Software controlled protection is useful in applications in which the WP pin is not or cannot be controlled by a host

processor. In such instances, the WP pin can be left floating (the WP pin is internally pulled high) and sector

protection can be controlled using the Enable Sector Protection and Disable Sector Protection commands.

If the device is power cycled, then the software controlled protection is disabled. Once the device is powered up,

the Enable Sector Protection command must be reissued if sector protection is desired and if the WP pin is not

used.

8.1.1

Enable Sector Protection

Sectors specified for protection in the Sector Protection Register can be protected from program and erase

operations by issuing the Enable Sector Protection command. To enable the sector protection, a four-byte

command sequence of 3Dh, 2Ah, 7Fh, and A9h must be clocked into the device. After the last bit of the opcode

sequence has been clocked in, the CS pin must be deasserted to enable the Sector Protection.

Table 8-1.

Enable Sector Protection Command

Figure 8-1. Enable Sector Protection Timing

Command

Byte 1

Byte 2

Byte 3

Byte 4

Enable Sector Protection

3Dh

2Ah

7Fh

A9h

3Dh

2Ah

7Fh

9Ah

Each transition represents eight bits

AT45DB021E 数据表(PDF) 21 Page - Dialog Semiconductor

AT45DB021E 数据表(HTML) 21 Page - Dialog Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74

数据表下载