QUALITY ASSURANCE

Sampling and inspection procedures shall be in accordance with MIL-Prf-38535, Appendix A as specified in Mil-

Std-883.

Screening shall be in accordance with Method 5004 of Mil-Std-883. Burn-in test Method 1015:

1. Test Condition, A, B, C, or D.

2. TA = +125

°C minimum.

3. Interim and final electrical test requirements shall be specified in Table 2.

Quality conformance inspection shall be in accordance with Method 5005 of Mil-Std-883, including Groups A, B,

C, and D inspection.

Group A inspection:

1. Tests as specified in Table 2.

2. Selected subgroups in Table 1, Method 5005 of Mil-Std-883 shall be omitted.

Group C and D inspections:

a. End-point electrical parameters shall be specified in Table 1.

b. Steady-state life test, Method 1005 of Mil-Std-883:

1. Test condition A, B, C, D.

2. TA = +125

°C, minimum.

3. Test duration, 1000 hours, except as permitted by Method 1005 of Mil-Std-883.

TABLE 2.

ELECTRICAL TEST REQUIREMENTS

Mil-Std-883 Test Requirements

Subgroups

per Method 5005, Table 1

Interim Electric Parameters

Method 5004

1

Final Electrical Parameters

Method 5005

1*, 2, 3, 9

Group A Test Requirements

Method 5005

1, 2, 3, 9, 10**, 11**

Group C and D End-Point Electrical Parameters

Method 5005

1

*

PDA applies to Subgroup 1 only.

**

Subgroups 10 and 11, if not tested shall be guaranteed to the limits of Table 1.

----------------------------

Electrical Characteristics of DG201A/DG202/883B

19-0041

Rev. C

Page 5 of

6