2

Regulatory approvals

The SensorTile module STEVAL-STLCS01V1 is marketed under the same FCC identifier (ID: S9NSTILE01) as

the SensorTile kit (code STEVAL-STLKT01V1) as a class I permissive change. The FCC ID S9NSTILE01 is a

limited modular approval as the module does not have RF shielding. The module was tested in the specific host

with model number STEVAL-STLCX01V1, belonging to the SensorTile kit (code STEVAL-STLKT01V1). When

integrated in a custom designed host other than the STEVAL-STLCX01V1, the SensorTile module STEVAL-

STLCS01V1 must be tested and FCC certified in the custom designed host.

The SensorTile module STEVAL-STLCS01V1 is IC certified with certification number IC: 8976C-STILE01 and

model number HVIN: STEVAL-STLCS01V1. Refer to the data brief of the SensorTile kit (code STEVAL-

STLKT01V1) for complete information on PMN, FVIN and HMN. The SensorTile module is certified as a limited

module because the modular transmitter does not have RF shielding. The module was tested in a representative

host with model number STEVAL-STILECX01V1, belonging to the SensorTile kit (code STEVAL-STLKT01V1).

When the SensorTile module is integrated into a different custom designed host, the developer of the host shall

perform additional radiated emission tests and satisfy technical and labeling requirements as per RSP100 section

3.2 http://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/sf01130.html for IC certification.

The Bluetooth radio power output is set by default at 0 dBm. The FCC and IC certifications refer to this operating

value. The power output can be changed up to 8 dBm by reprogramming the device firmware, but the change of

this operating value will require an update of the FCC and IC certifications, with additional radio emission tests to

be performed..

STEVAL-STLCS01V1

Regulatory approvals

DB2963 - Rev 4

page 3/5